What Have You Done To Your 3rd Gen Today?

Matches mine almost identically! Right down to the spot, curve, and current stop point of crack. lol

 

After six years, did the A/C mod. No rust on the frame (due to "Fluid Film"), but more of a preventative measure.

 

My 1st truck MOD! Before and after WeatherTech window deflectors. I've never had a window drip when wet so bad. Do the Toyota engineers not drive these things after a morning dew? Why are they not factory installed?

 

How hard were these to install? I've heard stories that some of them cause the window to not roll up all the way.

 

Much easier than I thought it would be. The back windows have a little clip to insert, they include the tool "required." The front windows just slide right in.

The back windows and driver's window closed right up no problem. Passenger front had a bit of issue. Adjusted a bit and it kinda worked. Instructions are VERY SPECIFIC about leaving windows closed for 24-48 hours after install. This allows the rubber to reform to the plastic. Makes sense. If there is an issue after 48 hours, ya'll will be hearing about it for sure!

 

thanks, I just ordered them.

 

Should be no problems. Love mine.

 

Night shot as requested…

 

Got new shoes last week. I've always went with BFGs All Terrains on my 96 Tacoma, but I went with the Toyo AT 3s this time. Love the tread pattern.

 

Did you make those glare shields? They look great! How much light still makes it on the license plate?

I have this, but the shields look like a good option also.
https://www.tacomaworld.com/threads...le-while-in-reverse-dir.707546/#post-25122024

 

Took off the air damn after 6 mo of contemplating. Sitting in the bed in case i change my mind haha

 

https://www.tacomaworld.com/threads/3rd-gen-cheap-easy-license-plate-light-glare-fix.739648/

 

Honestly this mod has been the biggest value per dollar mod I've done on the truck. $7 and I can see behind the truck when reversing way better than without.

https://www.tacomaworld.com/threads/3rd-gen-cheap-easy-license-plate-light-glare-fix.739648/

 

I agree, installed about 2 weeks ago.

 

I was actually contemplating adding some ditch lights onto it and sliders

 

I picked up a good-sized load of scrap cedar pieces the other day. I grill on cedar, also love burning it for the smell.

I didn't take a trailer so I could only get one pallet but it was a damn big pallet. Truck was close to, if not over load between the wood, camper shell, me, and the couple hundred pounds of gear (my phone autocorrected 'gear' to 'heat,' LOL) I keep on the truck.

I've also got roadmaster active suspension system and there was very little sag, if any.

 

Removed the bed stickers today. Wd40 seem to work the best on the glue. Cleaned it with glass cleaner. Still had a little image visible. Polishing compound by hand took care of that. Can't even tell it was there. Air dam is next.

 

be careful of the rear windows if you drive with them down. had my weathertech deflectors in for about 6 months with no problems then both rears fell out at different times

 

Ha Ha, should I?