What Have You Done To Your 3rd Gen Today?

Changed out the tweeters I got for my bday. Sounds great!

 

Thanks.
Did mine today. Was able to do without removing the TRD front skid. Drove front wheels on ramps. Laid moving blanket on concrete driveway.

Essentially removed the braces, put the small plate with 3 holes above the cross member. Installed (started the bolts, did not tighten just yet) the large flat plate, rear, under the braces, and then finagled the 3 long bolts that hold the front to that small plate above the cross member. Was able to hold that small plate in place while willing those bolts into place. Then installed the wing on the drivers side. Had to rotate the right brace out of the way to get the passenger side wing installed. Then finished putting in the rest of the bolts and tightened.

While the CRES plate will take more effort to defeat I suspect the aluminum one is stiffer. I haven’t taken a test drive but seems it’s a bit flimsy. It is a quality product. Got here quickly and they responded to my question quickly.

 

Started wiring up my OE aux power tray for some inbound goodies. Should be done and ready for ‘plug-n-play’ before the accessories arrive.

 

Believe it or not, we haven't seen much snow here. Nothing like we did in '96. Past few years it's been one big banger of a storm. Lots of threatening storms, but little else.

 

What took you so long? @AXL

Do you have bed lights too?

 

So after watching your install video, I think I want to use the coupler you used:


But since I don't have the dash doohickey you have, I think I want to make the hole in the lower switch panel. Should I just remove that lower section with the panel in it to drill it out?

 

Nicely done Manual transmission huh?

 

Are the 21+ LED headlights different than the 2020 LED headlights? I didn’t think there was a difference.

 

Looks great! Welcome back!

 

It’s the same.

 

For the cleanest install possible, yes remove it. It's really not that bad.

 

Thanks! You noticed the clutch fluid relocation bracket, eh?

 

its not an aux port its not round its smaller than a usb port, i will take a picture today after work and post it

 

Definitely DYIable. Like $130 from an online Toyota parts store like greico

 

Awesome

 

Forget the headlights. I want that sunshade! Lol

 

oh shit! The relays underneath is blowing my mind, I’m about to rip my OE aux tray out this weekend and redo it. How are the relays adhered to the tray?

 

Put new tires on yesterday. Dynapro AT2 255/75r17. They are on 17x7 Pro wheels and the truck has a 2” lift front and back.

 

The 2 ports in the center console are USB. One is USB-A and the other is USB-C. Both are for charging only. The smaller USB-C allows for higher current and faster charging.

 

Thanks for the information.