What Have You Done To Your 3rd Gen Today?

Installed the driver’s side grab handle. I don’t know why they don’t have this installed from the assembly line. Top bolt was kind of a pain, but wasn’t too bad.

 

Matching MESO dome light finally

 

R4T Bed Stiffners

 

Where did you buy that from? kinda want it lol

 

I got it from KTJO4x4.com

 

Wooo man that steep for a grab handle. Gonna have a drink or two while I think about that.
Thanks

 

Yeah no worries! I didn’t tell my wife how much it was hahaha

 

Running 4 Tacos in Denver Colorado check out the website. They sometimes have lots of items in stock and they also ship same day.

 

At least it was Sprite. Some loser lost a paint can in the road a month or so ago. I got it all washed off, but what a mess.

 

Jesus. How do people not secure their load..

 

Never seem to have those lower arm skids when the sales are up lol

 

Just got a pair of RXT today!

 

nice! I got mine a few days ago and then was sent out of town for work….

 

Twan a Kool dude in my book he helped me out today with my regear appointment. Them Dudes got videos/receipts. Of them off-roading sounds like u have a personal issue.‍♂️They definitely motivate me it’s a brotherhood.

 

Did you do the U-bolt flip or opt for standard?

 

I just did the standard. I have sumo springs and I haven’t looked to see how hard it is to get them to work with a flip kit. I also have not pulled the trigger on a lift yet, so I’m going to run option 1 with about 500lbs in the back full time. Should give me about .5 inch lift over stock in the back if my math is right. Once I get the lift I’ll swap out to option 2 or 3 and think about the flip kit

 

If it makes ya feel any better, I did the bumpers, winch and lights first all at the same time….in April. The Auxbeam has been 3m taped in the center cubby hole since then waiting for me to do this…finding the plate was the delay. When summer hit, that 3m tape would let go about every 3-4 days. That was actually what motivated me to get it found (was expensive) ordered and installed lol but it’s done!!

 

Not sure what you mean by bolts. There are no bolts, it just pops out…well with a bit of effort and plastic trim tools anyway. Yes they also pop back in. There are screws on the Auxbeam for the mount that’s not needed for this. The plate had slots where those same screws hold it to the switch plate. I did have widen two just a hair because they didn’t line up ‘perfectly’.

 

yes it is .....I'll just keep grabbing the steering wheel or the roof

 

Nobody checks the muffler bearings and the Jenson rods either.