What Have You Done To Your 3rd Gen Today?

Couple of gas cans.

 

I'm waiting for TacomaBeast to get the TRD Pro Style Grille back in stock so I can start my journey into modding. Looks the 17th could see some.

 

Thanks for sending that along. Nice looking bars. My only challenge is they don't say what the static load capacity is. Why do so few manufacturers do this? I am looking for a bed rack that can carry 1,000 pounds. So far the only one is the Leitner (which appears to be a great product but very expensive). In the end, I may have to go with the Leitner but I am trying to see what other options are out there.

 

My concern would be the load capacity of the bed rails inside the box. These rails are definitely hefty and I would have no issue putting 500-600 lbs on top of the pair. I suggest contacting Bill for more details.

 

Yea man I hear you. That’s why I went with 35% up on the windshield. The tint is ceramic too and it does really help out so if I do end up getting it removed I’ll end up going that route.

 

Added factory mud guards.

 

Opened my All-Pro bed stiffeners and will be installing this weekend!

 

Finished up installing full set of BAMF aluminum Skids today and got exhaust re route done at abc muffler in Benicia CA

 

Had a bunch of suspension work done to the truck. See over here for more ​

 

that wouldn’t work too well with my wife. She’s almost as in to guns as I am. I actually tried that pretty recently. Her reply was “oh really. You’ve had this gun for two years??? Nice try, the Hellcat just came out this year”

 

you know what you really need??? An SR5 hood to go with that SR grille. I’m going to do you a big favor and take that sport hood off your hands.

 

2019 Toyota Tacoma ReadyLift 3 Inch Front & 2 Inch Rear SST Lift Kit - 69-5531 and was installed by Duggy's Garage

 

IRC those lower ball joint bracket spacers are installed incorrectly.

 

Looks like you stopped another brake failure. Is that bare wire peeking through in that small indention? Or just a bad angle? Either way, Overland should correct their design flaw.

 

I'm not the the creator. Here's the link to the file: https://www.myminifactory.com/object/3d-print-toyota-tacoma-glove-box-drawers-105766

 

https://www.youtube.com/watch?v=JWC_gFG4t3c&feature=youtu.be

 

Ahh miss KTJO.
Just think she took on more than she can handle (Pre-orders, etc.).

 

Ya gotta admire her for doing what she does.

 

Thx for the info. At that price I think I will go with my own solution which might cost $20/ door and a bit of time to build my own wire harness tap.

 

Yup, her powerfolding mirrors are great!
First time dealing with some crazy wiring and near non-existant manual.
Was a great investment, but the initial down payment, projections, delays and the feeling that it might not work out, did make me second guess sometimes.

Lots of great ideas though. Looking forward to once she completes that A Pillar Grab Handle. I just can't do that initial investment anymore.