What Have You Done To Your 3rd Gen Today?

Well good catch. Didnt see that until you mentioned it. The bracket was sitting on that wire for few months so it might be bare wire. Ill have to patch that up.

 

Yeah, that's what I think too, maybe some more stuff I don't know about according to green room banned members thread

 

Since I buy almost all used guns, if she asks me if that's a new gun, I can truthfully say "No, it's old."

 

Wouldn't it be cheaper to go for KTJO's solution?
It is $67 for all 4 doors.

Comes with replacement LED injection molded trim pieces and pre made PnP wiring harness so you wouldn't have to tap.

Per door that would be around $16.

 

Did my question annoy? Why the bold lettering? I asked price and installer, I saw what lift it was in your post.

 

it's how was done on the website where i cut and paste those letters
for the price was $999+tax ,Duggys garage was $650 install and alignment

 

https://www.vleds.com/7443-50-hv-amber.html

Same as the type MESO uses in his Total Tail conversion kit. I run them and they are bright and look great.

 

Awesome I had seen these but wasn’t sure if they were too bright since vleds are known to be as bright as the sun I didn’t wanna be the a-hole that blinds other drivers.

I shouldn’t need resistors for these right?

 

Link to Hikari low beams?

 

Truck looks really good with those headlights! Quick review after a week or so installed? How was the install? If you used a Youtube video for the install, do you have a link? Thanks!

 

This one was pretty good

https://www.youtube.com/watch?v=bhGlwKRlAYE&list=WL&index=41&t=558s

Edit: Super helpful to release the fender clips from the engine bay side instead of yanking them from the outside

 

I need to make sure I have some spare clips when installing. Previous owner installed light bar and broke a few....everything is a little shaky up front.

 

New grill from Cutting Edge Offroad with color matched inlay and also MESO Customs turn signals was on the books for new additions!

 

Off topic, but I might not have been paying as much attention as I should have when I placed the order but I noticed they sell an install tool... is that needed? also with only 8k miles is a new seal needed?

 

I replaced the front turn signals with regular amber LED bulbs but had to install the resistors to eliminate the hyper flashing. Cost was reasonable, just need to do a little tapping into the existing wires.

 

Brightness wise, how are they? I was looking at getting Diode Dynamics LED turn signals which have different brightnesses around the same range and brighter than these.

 

My mistake, I understood the price to be per door, not all 4x doors. But if one owns an access cab like I do I don't see pricing just for 2x front units.

 

I have them along with the MESO Turn Signal Mirrors and the Triton Switchbacks and no resistors. They don't hyperflash in any situation.

 

They are definitely really bright. I don't think that it is any worse than some high end European cars though. The way I look at it is that it is an alert that should grab your attention and let you know that I am turning. Safety first