What Have You Done To Your 2nd Gen Tacoma Today?

Any drawings/info you'd be willing to share?

 

Toyo A/t II's and SCS Stealth 6's

 

Man, I wish I had drawings, but I deal with weld prints all day at work, so when I do personal projects, I just wing it. It's kinda nice going out to the garage at 1 in the morning to add something that you saw in a dream. If I had drawings, I would definately share. I used 4x4x1/4 square tube for the top part. I also used a lot of cardboard as templates. I may eventually get a print drawn up with dimensions. If I do, I'll start a build thread and include it in there

 

That's a good looking bumper CASTRATE.

 

Thanks

 

Ordered front & rear 5100's. They are on back order though and not expected until the end of May. Suck

 

ummmmmmmmmmmm


ummmmmm

 

very nice!

 

For a Prerunner, lift spindles.

 

Just installed my EBC pads and rotors.

So Stoked!!!

 

Put Fold a Cover on. G4 Elite Thanks Luke @ Truck Alterations for the deal.

 

Had the dealer deliver it to me at home. . Did the whole transaction over the phone. Never did that at before, IMHO a much better experience than visiting the dealership.

So hopefully I won't be stupid this time & will keep Tacoma #4 around indefinitely.

 

In my opinion, ProComp is decent but there is better. Depends on what you want though. If you're a prerunner then I would recommend spindles and billstein 5100's. But, if you "you want the best on your baby" then I'd go with an all out LT setup! Only reason I don't have LT is because it's expensive and got other priorities right now. Right now I'm just tryin to save up for some rims that will allow for spindles so I can add those onto my 3" toytec lift.

 

Don't you have a TRD OR? Spindles don't work on 4WD.

Matt

 

TRD OR & Sport come as prerunners in 2wd

 

Put some tension on the winch line since it unraveled a bit when swapping it over to the new bumper

 

Not worried about body flex and contact with the bumper? I see very little space between the fender and bumper.