What Have You Done To Your 2nd Gen Tacoma Today?

Well i count the stuff i did last night as today since i finished around 1AM.

All Pro Rear bumper
All Pro 3" Leaf pack
U-Bolt Flip Kit
5125s with eyelet adapters
Rear stainless steel extended brake lines

Tomorrow i have the front stainless steel brake lines to go in and ceramic brake pads.
Photos will be up tomorrow when its light out.

 

I tested out the icons while at out deer lease. And I love them. Also killed 2 doe. Red mud is all over the tailgate

 

repainted my fender flares and bumper

 

Thanks might do that how hard is the headlights?

 

My wife Ordered Weathertech floor mats for me !

 

Changed my 2005 satoshi grille to a 2011 grille...much much better

 

Yesterday I pulled the two stock plus the TRD skid off the front of my truck and pounded them back into shape. They held up pretty well to a few rocks. I repainted the areas that had the paint scraped off with some black Rustoleum. Then I trimmed 4" off the front mud flaps. So much better now. No scraping yesterday after that!

 

Got my Smittybuilt-made N-Fab Side Step Bars mounted....I dig em...I'll dig em more after I lift my baby and give em a reason for being there...That won't happen for a little while...

 

Washed and debadged:

 

Installed a Kill Switch today. I looked into a low-Jack system but it's really exspensive. Doing research on a GPS tracker that a friend of mine sells at his shop.

 

Took the tool box off and repainted it black because it was faded, turned out great.

 

installed all my switches
​

 

Heres a pic of it

 

Cut 4 inch's off front mud flaps

 

Lookin' good Boyd!

 

Boyd:
Man you work quickly. Looks great.

As for me I installed 2 small tie downs on the stock rails and put the Tacoma back in shape for daily driver duty. I also adjusted the foglamps lower, the beam pattern was too high. Trying not to blind on coming drivers. I will test them out tomorrow morning on the way into work.

 

Installed my emblem from metalmiller.

With scale


Rough sanded and sealed. I was going to sand and polish, but the subject matter works better a little rough.


On my grill


Back on my truck


IMO, the lines are to busy with the plastic lines from the original emblem under it. Not bad, but will be better on a satoshi.

 

weathertech driver & passenger over the window thingies (access cab/ didn't do back windows). yesterday i went to the Ford dealer and got a rubber plug for my cigarette lighter hole (don't smoke)

 

Ok here some photos of what i have completed over the last few days. Along with the photos i changed the oil, cleaned air filter and changed my spark plugs.

All this went in except the PIAA lights and locker.


First time off road


All Pro rear bumper


Flex

 

I thought that I would add some pictures to prove that I really did it.



Note, the wires coming out of the remote are simply extending the switch outside the box. The button still works for future troubleshooting (battery, etc). The wires from the remote are tied to the switch side of the relay. The wires from the power side of the relay are soldered to the white (ground) and the solid red (high beam) wires going to the headlight. It is probably easier to splice than to solder at the connector. The relay and the remote are sitting in the battery tray between the battery and the driver's side fender. Been in place now for a month and works great.