Wheel Bearings 2WD Base Model

Hi all, Happy Holidays. I am looking to replace my front wheel bearing soon on my 2009 Base model RWD. I was disappointed to see that my base model has the style of bearing needed to be pressed in rather than the hub and bearing assembly on most Tacoma's. I am somewhat new to doing my own work and usually do a lot of research before doing a job, but I cannot seem to find anything related to the specific model that I have. I will attach a picture.

From this point in the picture, maybe a dumb question but I do not see an axle nut to remove the hub - where would I go from this point to remove the hub and get to the bearing? Thank you for any help in advance, it is much appreciated.

https://imgur.com/a/68C7n2S

 

See post #4 for the OE procedure.
But the whole thread is a good read.

https://www.tacomaworld.com/threads/wheel-bearing-replacement.735669/

 

You have to remove the whole knuckle assembly.

 

Welcome to TW!