Wheel Hub Stripped

So I'm an idiot and didn't tighten my lug nuts enough after replacing my brake pads. On the way to work after about 40 miles I heard the wheel rattling, tightened the lugs and drove to work 10 more miles. After getting it towed back home I tried to pull the nuts but some were spinning. I managed to snap all of them off but now when I try to put in new studs the wheel hub has been stripped out to the point where some studs will not seat properly and always spin. Do I need to replace my wheel hub? Has anyone seen a seen instructions out there?

 

Pretty sure the hub would need replaced
https://www.tacomaworld.com/threads/wheel-bearings-hubs-press-service-4x4-prerunner-nsk-koyo.537080/