Whoops we made a mistake sliders for sale cheap DeMello

I'm having the other set installed on Monday! Thanks!

 

It was on the instructions
but it was just a combo of dull bits and impatience

 

Picking up my set tomorrow I can't wait. Thank you Tiffany for setting that up!

 

Thanks Tiff for setting this up, thanks Jason and crew for the great quality work and fast installation!

 

are any of these still available?

 

Same as above^ Still available?

 

Give them a call tomorrow. Tiffany is super friendly

 

We just sold our last set. They are being picked up today.

 

Are you guys offering discounts for forum members? On new purchases.

 

Do you have pics of what the pinch weld looks like after?

 

I did not cut them and tried to bend them but went off roading today and.... I am going to have to cut them. the pinch weld was rubbing on the sliders pretty bad and I could hear it inside the cab. on the street it sounds fine. but off road OMG noise galore. and not sure if its just me but front part of slider may have been rubbing on body of the cab.. not sure. I'm going to cut the pinch welds tomorrow and try to slide the sliders more toward the rear.

Also got some battle damage already and less than a week

 

I just got sliders put on a few days ago and noticed the legs of the sliders touching the pinch weld. I pretty much feel everything on the road and it's ridiculous. They say 1/4" space is good enough. How much do you have?

 

Pretty much zero clearance. Enough to fit the sliders on snug. lol but im cutting it tomorrow.

 

I just installed mine yesterday. Took a grinder with a flap disk and notched around where the support tubes pass the pinch weld. Easy to do and you cant see it!

 

remember to paint the part you cut. don't want it rusting.

 

I did, but thanks for looking out!

 

I grinded down the pinch weld. And tested it in a little dirt parking lot. It made minimal noise. Only thing i noticed was the front of the slider is hitting my cab body and started to take paint off . Temporary solution? I put 3m tape to use as a buffer.
But my next solution is to go get a metal spacer to shim the bottom of the slider to drop it down some.

@JDEMELLO do you think it is possible to send me some of those big metal washer plates used for the big holes of the side frame? Or do you know a place that would carry those metal plates?

 

I have the same issue with the ones I got installed this week. Mine is only on the driver side. It seems like the driver side slider is placed a little bit more toward the front of the truck compared to the passenger side. Is your's the same?

 

Yup drivers side. Passenger has a half to an inch space

 

Looking at the pics in the original post it looks like the mounting holes are a little wide. Do you think it would be possible to loosen the bolts and pull the sliders toward the back a little?