will this muffler be a good fit?

looking to replace my stock muffler, I think this is the correct match up I need. Just looking for someone to double check before I order it. Anything else I need? Just going to take it to a shop and have them put it in.

 

i think you forgot the details...

 

Sure did... Here you go

http://www.summitracing.com/parts/WLK-17560/

 

2.25" and the muffler has a center inlet and offset outlet.

 

Are you sure about the inlet/outlet? When I was under there mine was both offset, but lined up in the center if that makes sense. My muffler is shaped like an oval, the inlet is offset to the top and the outlet is offset to the bottom. Not as much of an oval as the dynomax, but not quite a circle. Would the muffler shop be able to just make it fit if I get 2.25?

 

there's enough play in the hangers that it doesn't make too much of a difference. i got a flowmaster 40 with an offset inlet and a center outlet. i just wouldn't go with an offset in and an opposite offset out.

with creativity, anything can be done and work well. my flowmaster actually has 2.5 in fittings, but with some muffler sealant, a shim, and a really tight clamp, i've had it on for 3 years with no leaks and no play. so a good ehaust shop should be able to make just abotu any muffler you buy fit.