Wiring diagram for MAF sensor

I am installing a chip on my truck and need to hook it up to the maf. I am trying to identify the two wires one being the intake air sensor wires in this group of wires. One is the signal wire and the other is the ground wire. Any info on where I could find a diagram would be greatly appreciated. Thanks for any input into this!

 

I've a diagram - what info you need??

 

Pin out as follows; (2012 RC 2.7L)
On MAFM
3 R-Y VG
2 R-W E2G
4 R-L THA
1 L-W +B
5 BR E2

 

I am trying to locate the IAT wires. The colors on the harness are green, red with blue line, red with yellow line, red with white line and blue with a white line.

 

my print does not show those except for the R- Y And called VG per my earlier post. As you at the MAF connector??

(2012 RC 2.7L)

 

Wiring may be different for v6??

 

Mine is the 2.7L.

 

The wiring sequence you put up which of those would be the ground?

 

I added the pic of it to my gallery. Not sure how to get it to this message.

 

I'll pm you to get this off the Thread

 

unless its a URD, please dont go thru with the resistor mod

 

Why do you say that Justus?

 

The urd maf calibrator works wonders...... Resistors, not so much. Its an eBay scam.

 

The MAF and the IAT are two different sensors.