1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Wont shift into gear

Discussion in '4 Cylinder' started by Super Heros Inc, Oct 23, 2011.

  1. Oct 23, 2011 at 4:24 PM
    #1
    Super Heros Inc

    Super Heros Inc [OP] New Member

    Joined:
    Apr 6, 2011
    Member:
    #54432
    Messages:
    2
    Gender:
    Male
    First Name:
    Preston
    Dover, DE
    Vehicle:
    06 tacoma
    when i first start it up it moves like it should into all the gears but after I let the clutch out that first time and reengage it, the stick doesn't want to go into any of the gears sometimes if I pump the clutch while pushing the stick it will go in but with much resistance... does anyone have any ideas of what could be wrong? its a 2006 tacoma manual transmission with about 80000 miles, all fluids are good and nothing is leaking
     
  2. Oct 24, 2011 at 8:50 AM
    #2
    jassco

    jassco Well-Known Member

    Joined:
    Aug 3, 2009
    Member:
    #20568
    Messages:
    607
    Gender:
    Male
    NH
    Vehicle:
    2023 TRD Offroad
    Clutch is hydrolic, so looking for fluid around the slave cylinder on air in the line is more likely especially if this was a sudden thing. Get under and look for anything wet around side of trans. Could also be a failed seal inside which you wont see.
     

Products Discussed in

To Top