Lets see your most Unique Mod

X4 oh wait... Will do gonna add a little to it tomorrow and will post up some pics, going to try and find an American flag tomorrow too so i have something more official for you guys

 

Sorry Parker I was too busy looking at 23dec2007's sig to read your post

 

Ya they are pretty great haha, whenever i see him post on other threads that i post on i like what i see at first then i see his avatar and get creeped out haha

 

You sir are a genius!!!

 

sub'd for future reference

 

lol

 

Heres the write up. sorry, havent been on in a couple days. drain valve is slightly lower than the bottom of the rear bumper, but i dont wheel.. yet. it will be relocated to where the spare tire mounts when i get tires that are too big to fit under the bed. the tank, being a 2.5 gallon would not fit anywhere else without some timely modification.

http://www.tacomaworld.com/forum/2nd-gen-tacomas/277563-vallions-board-air-writeup.html

 

Everytime I go to a tacoma meet 5000 dollars in some mods and everyone just likes me dam cup holders!
TRD BED cup holder
You get one from a marine store or ebay and then you find a place you like and drill some holes for the screws and your done. It took me 5 minutes.

 

That's a great idea. Might be copying this.

 

^ I used the same cup holder in my Supra years back. As bad ass as those cars were and as well thought out as they were engineered it was mind blowing that there was no cup holder. I attached one of those down by the footwell/door sill on both sides it worked perfectly. Folded up when not in use you didn't even notice but when you needed them they were fantastic. Love those cup holders. I was looking for a picture to share but I fail.

 

There is a write up on how to add locks to them. It's easy to do.

 

Stock shifter mod

 

Good to see this thread bumped, it's one of my favorites. That shifter looks cool!

 

My OBA install. Not quite like the rest

 

That is way cool. Are you running air lockers?

 

Super clean. Is it loud in the cab when the compressors kick on?

 

I found this guy (http://www.ebay.com/usr/taniadeick?_trksid=p2047675.l2559) selling engraved gun parts and gave him a call. Long story short, $7 + S&H and about a week later I have my own customer shifter. I've since filled in the engraving with a black paint marker to make it stand out a bit more. Glad you like it!

 

Updated photo

 

I got the idea from a member on here, so I can't take the credit for the faceplate relocate, but it's probably one of the most involved modifications I've ever done from a sheer work standpoint. I have probably 15 hours into it easily.

 

What is on the panel directly above the temp gage? Four dots to the right.