OME tire/wheel advice

I installed the full OME suspension lift recently. Dakars in the rear, no spacers in the front which gives me appx 2.5 inches. I will be purchasing stealth custom series 6 wheels, here are the specs:

Size: 17x8.5 / 20X9
Bolt Pattern: 6x139.7/5X150
Backspacing: 4.30" / 5.50"
Weight: 24lbs / 29lbs
Hubcentric: Yes
Max load: 2100lbs
Offset: -10mm / +12mm

Does anyone have this combined setup? If so, what is the max tire size that can be run? Any input/advice would be much appreciated.

 

285/70 on the stealth 6's and the same suspension setup for me. I would change the front bump stops to the wheelers taller ones though, you will rub at full bump. Also you will rub on your cab mount

 

Nice dude, thanks for the reply!! Did you run into any issues with any rubbing against UCAs or does the backspacing of the stealth 6 clear everything? Would you mind sending me a few pics???? Are you happy with your setup?

 

That was a long time ago. I did not rub the UCAs or the frame. I rubbed on the top of the fender / flare in the front, taller bumps will eliminate this though as the rubbing was minimal. I rubbed the cab mount, but a cab mount chop will also get rid of that.

I have tons of pics in my build thread http://www.tacomaworld.com/forum/2nd-gen-builds/290574-reds-build-bs-picture-vid-thread.html

I'm running 35s now

 

Im not sure what youre reffering to when you say bumps, can you fill me in please?

 

Above your lower control arm (front suspension) there is a protrusion from your frame with a rubber foot on it pointing down, when you stuff the suspension your lower control arm hits it and prevents the tire from moving upward anymore. If you change those out (takes a few minutes per side) to taller one (from wheelers for example) it will stop the tire from going up too high.