Wiring bed lights.

I have lights that are sitting on top of my headache rack, whats the best way to route the wiring to the front into the engine bay?

 

bump

 

Depending on how your headache rack is made and where the lights are pics might help but drill a hole in the supports that run down the truck put the wires through that hole down through the bottom of the rack run them in between your bed and your cab and zip tie the wires to any harness underneath all the way to the battery

 

Just run the wires down through the engine bay, along the frame and up to the bed? Is that what you recommend? Im wiring up some bed lights and am wondering how is cleanest and easiest way to do this

 

I have bed lights so I ran mine down the rear of the bed, along the frame to a small rubber grommet underneath the driver's seat, through the grommet and into the cab, and finally through the firewall and into the engine compartment.

I used this thread as guidance:
https://www.tacomaworld.com/threads/rigid-industries-sr-q-back-up-light-kit-install.309922/

 

Yessir drilled out a tiny hole up by the bed rail to run the wire through and looks great cant see any wires or anything

 

,

I might be doing this, just posted a thread on tapping into the trailer harness or something if there is steady 12V on a wire in the ass end. Your method seems easy enough.

 

I think the whole process wired up and ready to go took me about an hour and that was more cleaning under the bed rails to make sure the lights would stick haha