What Have You Done To Your 2nd Gen Tacoma Today?

Nice, wish someone made a set that hinged from above instead of below.

 

4xinnovations makes one that goes right next to the driveshaft. Actually protects the driveshaft a little bit

http://www.4xinnovations.com/2005-2015-Tacoma-Traction-Bar-Set_p_35.html

 

"Will not fit the double cab long bed."

 

Running the wiring and plumbing now

 

Fits perfect

 

Lol and X2. Where are those guys?

 

Just had a brand new frame put under my 2005 Tacoma 4x4.To date trd super charger ,urd 2.7 pulley, meth injection,7th injector, jba headers, Doug thorley pipe bomb y pipe,urd spec 3" high flow cat back system,and a u-conn controller from urd,trd cold air intake.

 

Forgot fuel pump upgrade.5100 series shocks set on 2nd highest lift( so the truck is level).everyone should check out urd!!!!!

 

URD is a vendor on here

 

Got lucky, and I also changed the air lines to go straight down through the bed and not out of the side of toolbox that way you can't see anything coming out the toolbox much cleaner

 

Same issue on my '13. I wanted to blame to rust-proofing guys, but didn't have any proof.

 

woosh woosh woosh woosh

been there done that twice......awesome stuff

 

And extra money goes buhbye, and "oh look a badass concert I wanna go to......oh yeah can't........ KIDS" , and no more money and oh yeah, money goes out the shitter.

 

Finally finished up my fuse panel. Mount has been finished for a while. Now just to install it for good and route wires up to my overhead console this weekend.

 

Yes!!!! Pelfreybilt just shipped my bumpers and sliders! Woohoo!

 

Question for people, can message me answers if anyone knows. But what is a good way to keep the wiring for lighting and stuff clean when it comes to the Relays and all of that stuff?

I already have a Blue Sea 12 Fuse Panel, but am mainly concerned about cleaning up the Relays and such for the lighting/switches/etc.

 

Lexan/Polycarbonate

 

Yep. Was way easier to heat and bend to shape than I thought it would be. I went this route based off an older thread on here:

https://www.tacomaworld.com/threads/how-to-secondary-stand-alone-fuse-block-install.120561/

 

You can follow Nates lead https://www.tacomaworld.com/threads/nates-build.346735/page-11 and put everything in one location or do what I did and ditch the bluesea for a SPOD and be done with it

 

Just had an aero turbine 2525 muffler put on to replace the flowmaster I had. Sounds a lot better