What have you done to your Tacoma today? 1st Gen Edition

Pretty good deal...

 

Better get it!

 

So I recently got that truck, and look what i've noticed....truck runs fine, but compare my belt (first photo) with the way it should be installed (2nd photo). So...thats next.

 

Its that or a CVT lol

 

It's already gone. I can't see the ad anyways

 

will these fit with the tundra brake upgrade its from a 2013 toyota tacoma and they are 16", i know i should go with 17" but there is a killer price i can get on these rims right now...so will they fit my truck properly if i did do the upgrade?

 

Got more parts for my engine. Pauter rods, ARP head and main studs, brass freeze plugs. At the rating I'm going I might have the bottom end done by August.

 

FYI all your rigs rock, im a TW stalker, never posted before but check in often to see your rigs. first post/question. anyone ever "notch or cut" their bedrails?

 

Welcome to tw. What would you notch or cut bed rails for?

 

Pretty sure I don't see a topper or an RTT.... just sayin'

 

Welcome to TW.

Beautiful truck

 

THX brother , i got a unreal deal on a toolbox for truck, but i drive a stepside taco, and it wont fit by an inch. Been doing geometry in my head and with damn measurements, dont think itll work even i notched it because of the wheel well and access inch i need for lid to open. so i guess ill throw box back on CL

 

Finally upgraded the suspension. Bilstein 5100's up front set at 1.25" lift and 5125's on the rear.

 

Thanks! I know who you are (creepy...) from the squeaky clutch pedal DIY thread. Thanks for your help as well.

 

lol... glad I could be of assistance.

 

Anyone with a 96 3rz wanna be super helpful?? I snipped the rear o2 plug a while back to resolve a wiring short and I can't find the plug now. Can someone crawl under their truck and tell me what wire goes to what wire? I checked the front o2 and the colors coming from the harness side are different so no luck there. On the o2 sensor I've got 2 blacks, a blue, and a white. On the harness side I've got white with red strip, large black, red with white stripe, and brown.

Inspection runs out in a few days, need to keep this turd "street legal"

 

• Installed my scan gauge.....shout out to @paranoid56 for the mount!!!
• 

 

From the holy almighty manual:

Harness side connection shown


You'll have to play trial and error with the two black wires.

Also, this thread's pics might help:

https://www.tacomaworld.com/threads/how-to-replace-o2-sensors.194366/

 

Just remember this when you fighting the urge for bigger tires.

 

Nice setup....what shifter knob's are those?