What Have You Done To Your 3rd Gen Today?

The dealership here washed my truck after they did the service and i didn't even ask. They didn't fully detail it or anything but they washed the outside. I was happy.

 

So I am trying to figure this out and wondering if anyone has got a clear answer on this. I know what the manual reads about the fog light bulb size. But how exactly (without taking the bulb out) do you know if it's H11 or H16. I saw some posts saying Trds are h11 while the sr5 were the low watt H16, But then read posts of people with Sports having H16's. Any clarification?

 

I have HID H11's in mine and my truck is a TRD sport. I'm not sure what SR5's are but I would imagine the same since it's the same wiring.

 

I to like the non scooped hoods its hard enuf seeing over hood offroading.

 

Hella HD11, yellow, in mine. There are fogs off a 16, put on a 15, work great, no probs.

 

It depends on if you have OEM LED DRLS. If you have OEM LED DRLs you have H11 fogs.

 

I think if you push the direction button on the upper left of the screen it will change to the way you want. I know it does. I am not near my truck right now but I am positive you can change it. Little help for him guys.

 

Awesome man, you get a chance to get any night shots of them?

 

Oh man those look so classy!!!
Where!!!!????

 

To get ready for future mods I replaced the pocket with a switch plate from https://www.tacomaworld.com/threads...ecause-the-thing-i-wanted-didnt-exist.415922/.

 

I think most mean the windshield. Mine has like 10 chips already.

Mine doesn't look like that. It's an actual rotating compass.

 

This looks good. Where did you get the blank switch plates?

 

Yes sir, I know. It was Segue into my story!

 

http://www.shapeways.com/product/CH...-switch-plate-for-16-tacoma?optionId=59283471

 

What did those beauties cost/wattage and do you happen to have a direst link to were you bought them from?

 

Ordered the rear black bumper caps to replace the chrome one. $156.43 including shipping from Camelback Toyota(TW vender)

 

I got the blank switches on ebay here: http://m.ebay.com/itm/TOYOTA-OEM-Ta...5539AE010C0-/331419917522?txnId=1274956902014

 

Yes. Mine leaked on the drivers side rear corner. I followed the advice of those with the door wind noise. I bought some 3/8ths inch OD laytex tubing and used about a foot on each side. If you look at the rear corner seals they are foam tubes. I slid one end of the tubing into the rear seal and the other into the side seal. Like with other things saliva is a great lubricant to assist with the process. It took a bit of patience and fiddling but I managed to get both ends in. The latex tubing will make a bend where there is no original seal. It will cause the OEM seal to be more firm. I can now point a hose at the cornere of the lid with no water inside. Hope this helps and works for you.

 

Awesome, thank you! My compartment gets wet I find, this should help

 

Crown Toyota has taken the same stance on washing vehicles after being serviced. May be a CA wide initiative. The only time you'll received a washed car is the day you purchase it.