What Have You Done To Your 3rd Gen Today?

Finally finished my LED blacked-out tails.

 

Wow those turned out freaking amazing

 

120 volt power to 12 volt in the house ?

 

NO, they are 120v lights. I have to have the power inverter on for brake lights.
(joking)

Just a 12vdc power supply for testing before they get installed.

 

wow , they look great , I did not know that there was such a thing .

 

...................................
Since you replaced the rear leaf springs, do you still have the off-set rear wheels problem like on the stock leaf? Link explains the off-set problem with pictures.

https://www.tacomaworld.com/threads...to-fix-the-rear-axle-off-center-issue.467472/

 

How did you hang your Tepui?

 

Welp. I'm gonna buy these. So thanks, and dang you..less money in the kids college fund!

 

265/75/16 BFG'S on ProComp 7032

 

Holy shit. That thing drives on walls!

 

I lag bolted some 2x4's to the ceiling and the just use regular ol' tie down straps. I started with ratcheting straps but the toe down straps work better. Only takes a few minutes to raise up the tent. And only cost around 20 bucks. One day I might install some sort of electric setup, but this seems to work fine.

 

Has anyone attempted to take the vynl covering on the doors between front and rear doors?

 

I did not have any of the shifted/misaligned/off-center wheels mentioned in the post you started and described, and by the looks of the engagement with the above thread it seems like what you're describing is relatively isolated... there's no misalign as it sits today. Rear wheels were centered to the truck stock, with new wheels, and now with new leafs.

 

This has been done by many guys on here

https://www.tacomaworld.com/threads...e-cabs-are-just-a-decal.451602/#post-13251973

 

A lot have. If you heat it up a bit it pulls off nice and easy. Just start in a corner. Might need to use some googone or WD40 to get the excess sticky stuff off.

 

Thanks guys!!!! I appreciate it.