Wheel/Hub bearing!!

Ok guys my trucks been going through about two huh bearings a year, my trucks a daily driver/ work truck.. I'm looking for possibly a better bearing other than orielys 80 dollar specials

Any help is appreciated! Looking for some insight on what better bearing my be out there?

I run a 33 on 20x12.50x -24 offset

 

there are a few guys on here that sell good replacements. take a look in the forsale area.

 

@BamaToy1997
Toyota OEM parts and added greasing. Preassembled to your door!!! Plus, he's pretty close to you. He also gave me some help over the phone before install.

 

Any pics of the condition of the spindle with the hub removed? There is a replaceable seal on the back side where the CV joint is. If that is leaking you may get moisture, and even rust inside the spindle. If there is enough it cold make a mess of your bearing, but it's unlikely you didn't see it.

Both of the vendors on this site make a quality product, using quality parts. If you try to duplicate it on your own, say with RockAuto, you'd be hardpressed to save yourself more than 20 bucks or so. I'm sure they would each be able to help diagnose your issue.

You already heard about Bama, The other one is Kev @nj636.

 

The key to proper installation is torque of the CV axle nut. It is crucial that you tighten to 173 lbs-ft. Do NOT use an impact to install the nut. I would be happy to provide you any other information you would like. I have a 24m 23k mile warranty. with my assemblies.

 

is it me or does the front wheel look tilted in?

 

This. I bought them, installed them myself and they fixed my problem. Would buy again 100%

 

Like - camber?

 

Camber set all the way for the tire to lean in but spindles and hubs are fine no slack in the nor wear, truck only had 102,xxx miles

 

So how much for a set sent to me?

 

PM sent!