What Have You Done To Your 3rd Gen Today?

Actually most of the manufactures of tonneau covers are owned by one conglomerate.

 

No kidding? Not surprising in this day and age I suppose. But damn at the choices.

 

Finally did something I should've done a while back... CHANGED THESE DAMN LIGHT BULBS TO LED'S!!!!

 

https://truck-hero.com/about

Yeah Truck Hero has the money.. Click on "Brands at the top of that page and it shows the tonneau makers it owns.

 

I washed mine.

 

Me too

 

Threw this baby on today.

 

Dipped my bezel and logo.

 

looks bitchin

 

what in the hell was it and how did you do it? mine is getting worse by the day

 

Big day for me. Swapped the original 265/65/17 spare tire and 7" steel rim for a new 265/70/17 KO2 spare on a 7.5" aluminum wheel. Now if I have a flat my spare will be the same size and the wheel will be the same offset with a tpms sensor. Freekin awesome I must say. So now I figure I will eat a nail sometime next week. Karma.

 

How do you get the 5th TPMS to work?

 

how much did your front end sag after install?

 

Same here. I'm running OME 888 coils up front, HS AAL in the rear with the factory overload leaf and 5100s. I have not been offroad yet but have been unable to find any angle/obstacle in the urban jungle that would make me rub. I have 4.5" backspacing with 0 offset and 285/75/16 Duratracs.

 

I'll wait for the video. I'm in no rush. I've gotten everything removed before up to the climate control being removed bc I was going to paint it Barcelona Red but thought it would be too much and so I put it all back together. So I must have been pretty close if I would have just continued removing sections.

 

Just follow your heart.

 

Like the clean panel for your switch. Where did you get the panel to cover the coin box?[/QUOTE]

 

https://www.tacomaworld.com/threads...ecause-the-thing-i-wanted-didnt-exist.415922/

 

Looking forward to the video- going to be swapping that valence out on my rig eventually

 

About half an inch is all. That's why I went with this instead of a full 150 lb bumper and winch. I had a 3" lift all around with the OME lift kit so now my front end is a little lower than the rear. It should even out with skids and rear bumper I have on order.