What Have You Done To Your 2nd Gen Tacoma Today?

Good suggestion! I actually bought some cheap "door guards" to cut and apply to the edge for protection!

 

And.... finished my radio install...


Full post...

 

Bought this grill today. Factory matched Toyota Black paint code 202. This is 1/2 way into getting my black out look on my sr5.

 

Awesome post and very detailed guide! PM incoming pertaining to your install!

 

Did the A/C drain mod today, only took a few minutes. Needed a couple small hose clamps, a 3/8" fitting and 3/8" hose. Only snugged the hose clamps so it can't fall off, no need for these to be tight AF

Followed this thread: https://www.tacomaworld.com/threads/rust-on-frame-with-a-c-drain-mod-fix.444138/

 

After finally getting my Cooper AT3's on the ground, today I installed some RB mud flaps, I like them. Got tired of the front stock ones snagging things all the time.

 

Looks good, do the RB flaps use the same mounting bolt and clip holes as the factory flaps?

 

Washed it

 

Just got my black "Ghost Flags" and TEQ Stickers from Hawaii today! Will get some pics when I get them put on. Thought the TEQ stickers would make an interesting replacement for the Tacoma Badges on the sides... Thanks CBoy808.

 

I know this is a long shot, but is there anyone on here around southeast Iowa who would be willing to help me install my new suspension? full replacement, coilovers, leaf springs, rear shocks

 

Alignment, tires, lift..

 

Shortened my antenna 12 inches, reception seems to be the same. Like the look about level with the roof line.

 

Easy enough to do and your truck so your decision, however, sanding or grinding to smooth the corners is permanent, cannot be removed and looks cleaner IMHO.

 

New tires yesterday!!

 

​

 

How much trimming did you do to "fit" them in without rubbing, tires that is. ? Looks great!

 

Anytime fogs....
Interesting side effect... the dash indicator for the fog lights doesn't light up anymore... is this normal? Don't recall reading about it anywhere.
Left the extra wire for when I figure out how to get to the underside of the fuse box(any tips appreciated). The wire runs from the fog light relay down through the loom, all the way to the big fuse box... got stumped and chose to drill a small hole to feed the wire into the big fuse box. Then i ran the stripped end of a wire down the cell adjacent to the green wire and folded it back up to contact the green wire. Not as clean as I wanted but it will work for now.

 

Why is that?