Pelfreybilt Off-Road

Would have gotten a Pelfreybilt fairlead but it came out AFTER I had my Factor 55 fairlead. And now, don't want to mess with what I have.

 

That is the angle of the picture. Since it protrudes past the fender it appears longer, they are flush with the wheel well.

 

They are designed for the factory flares, it does work with the bushwhackers however. The bumper follows the profile of the factory flare and the bushwhackers it tucks in under a touch.

 

Anyone know if you need a coupon code for pelfreybilt's Labor Day sale? Or are the prices on their page the sale price?

 

https://www.tacomaworld.com/threads/pelfreybilt-labor-day-sale-2017.508114/#post-15927228

 

Thank you! I was reading through socalduckslayer's posts and couldn't find it. Wrong place to search. Thanks.

 

Looked around but didn't find- are there any torque numbers out there for steel bumper install on 2012+ front bumper?

 

https://www.tacomaworld.com/threads/the-torque-spec-guide.318116/

Scroll down till Exterior Misc. Looks like 43 lbft.

 

New to the Pelfreybilt Ohana here's my front bumper with Line X Lmk what you guys think

 

Installed the high clearance rear awhile ago and just getting to the camera relocation. Found these in the baggie with the mounts...anybody know what they're for?

 

Should look like this

 

Looks awesome!

 

Thanks!

 

@Pelfreybilt , will my swingout spindle rust or have other problems if the gate is removed for a while? The bearings/etc will stay greased and inside the gate.

Or should I just cover or keep a thin layer of grease on it?

Matt

 

I had mine off for a while in the northeast salt hell. I just threw a layer of bearing grease on it. Saran/plastic wrapped it. And then taped it up with black duct tape so it blended with the bumper. Looked good as new when I put the gate back on

Also protected it from potentially banging something into it and gouging it or something.

 

Definitely cover it in grease and maybe something like described above. You will definitely get some rust if you don't

 

Anyone have shots of their rear bumper with rotopax double stacked? (2 or 3 gallons)

 

Also have a general fitment question. Is it normal to have some troubles with the locking pin correctly fitting? We had to dremel it out a couple times before it would pop in. Still needs a good whack to open and close.

 

This is what I did also.

 

Here is a pic of it slid over.