What Have You Done To Your 3rd Gen Today?

FYI....Home Cheapo has a 4 pack of Husky ratchet straps for $10. not a bad deal at all and the seem good.

 

Hey, looks interesting in the ad, have you installed? Pictures?

 

http://www.lowrangeoffroad.com/2016...ift-kit-medium-load-2-ometac16mksb-11430.html

 

It's just the surround that is chrome. The inside is blackish/grey. Glad I like it, one less thing I would have to buy.

 

Here you go...

Rdash Carbon Fiber Dash Kit

 

Yes but it’s very easy. Look for some YouTube videos.

 

What's the WLL for those?

 

Nice. I've been thinking of doing something very similar. Did you do a write up on how you did it?

 

Installed my compressor in the bed side cubby, put a power panel for camping and switch for the compressor, plumbed air to the rear bumper. Currently my air hose is in the cubby, but when I go camping my bed is packed full and I’ll have my air hose in a small bag so that all I’ll have to do is flip the switch, grab my air hose, and walk around the truck to air up. I didn’t want to have to even open up the cubby door when I’ve got it packed full.

 

That’s such a great spot! I absolutely love having my Water and air hookups there. Super convenient

 

Installed predator steps, mud guards, exhaust tip, and OEM pro grille. Again, these were all taken off from my 2016 b/f trading it in. The grille swap was pretty easy overall, the hardest part was probably taking off the lock washers from inside the grille (middle center piece) to replace with the garnish on the new 18's. Very pleased as I did not get any error messages after grille swap.

Scheduled for a 3/1 lift tomorrow.

 

I’ll repeat... the 4x4 emblems are only on non-TRD 4x4s. If you see a TRD with the emblem it was added by the owner, not the factory.

 

I put them on my vents, the rest was the 'gel' coated CF and over $200 for the kit, I would get the ebay one since I think it looks better and no doubt easier to install, see here:
https://www.tacomaworld.com/threads...-3rd-gen-today.399305/page-4870#post-18403593

 

I agree, I believe that all of the 4X4 emblems on any of the TRDs were added on. This conversation got me going and I just ordered some black 4x4 emblems for my truck.

 

Got a set of TRD center caps for my KMC wheels.. i had to make some custom plates to fit them there but i love how they came out, super clean

 

17"

 

Ooops, my bad.

 

There is info on the spare hoist relocate on the linked thread below. Look on page five post #97. This build thread is great! Very inspiring. Good luck!

https://www.tacomaworld.com/threads...oma-builds-on-to-new-adventures.528480/page-5

 

Miss my 2nd gen

 

https://www.tacomaworld.com/threads/3rd-gen-led-reverse-pods.540403/ Can’t take credit for it.