Oem Hard Cover?

2 part question I got what I think to be a oem cover for a good deal my truck didn't have one from factory and Toyota doesn't sell them only from factory so found one. First question are there special bed rail covers that have cutouts to mount the cover? Second this piece is broken will it be hard to find it goes were the fold is?

 

Yes, but they're pricey:

https://toyotaparts.mcgeorgetoyota.com/oem-parts/toyota-protector-6624804070
https://toyotaparts.mcgeorgetoyota.com/oem-parts/toyota-protector-6624904070

A better plan is to swap with the person you're buying your tonneau from. That's what I did. They just pull up, carefully.

Don't forget to get the little rubber plug pieces that sit in the gaps on each side below the head rail, iirc they cost $60 to replace.

 

Which rubber plug pieces? The guy that has the cover his was just cut that's why I didnt take them....

 

These are the trim pieces, they go in the gaps between the bed sides and the head rail:

https://www.tacomaworld.com/threads...-cover-leaks-everywhere.498602/#post-15494031

Left and right sold separately.
https://toyotaparts.mcgeorgetoyota.com/oem-parts/toyota-side-panel-cap-6254104010
https://toyotaparts.mcgeorgetoyota.com/oem-parts/toyota-side-panel-cap-6254204010

Honestly you could probably do about as good of a job sealing up the little gaps with silicone and some foam rubber.

 

That small piece that fills that gap broke on mine also. The other half of it should still be attached to the cover. I took it apart and JB welded it back together and havent had a problem with it since.

 

Update. Got the cover on last night in welded that piece with JB weld haven't put it in yet. Will probably have to order those rubber pieces and look for light but not to shabby.

 

The jb weld didnt hold up anyone know where I can get that piece?