What Have You Done To Your 3rd Gen Today?

Current situation right now, figuring out the fit and finish of these 35’s first hand.

 

I'd like to know, too. I've got the MBRP dual on a ACLB. There wasn't a long enough straight section ahead of the muffler, where others had said it should go.

 

Anybody know where I can find a polyurethane exhaust isolator with the following specs: 1/2" (12mm) holes, 1 and a 1/8" inch (30mm) center to center between holes, approximately 1"(30mm) overall width. My driver side exhaust tip is sagging below the passenger side tip. Sag does not show up in pic.

 

Mounted new Plano case. Only have about 1 1/2" clearance, thats with truck unloaded so it's perfect!

 

You might want to re-read those directions. Pretty sure they say to close the tonneau cover first, then close your tailgate so that gasket isn't sitting on top of the tailgate.

 

Complete wash n wax and inside detail. Also added the Tufskinz TRD letter inserts on the the pro skid.

 

Full Taco pic of my TRD Pro wheel caps

 

A couple of similar threads have already been done this year. You can also start your own.

 

new rimmy rims...

 

Faux Pro Grille? Bed Mat?

 

Finished my Bussman Fuse Box Build, just have to install it when I get around to it. Also installed interior LED's and Molle Panels in the rear storage areas.

 

Getting prepared for gusset-palooza next weekend by getting the cam gussets welded up. Will be doing cam (obviously!), spindle, and coil buckets. The cam is the only immediate need (had one tab tearing off, and found another pushed flat), but figured might as well do the others since part of the work would have been done anyways.

 

I did a hand wash, rinse, McKees 37 Hydro Blue, and dried my truck off today. Easiest way to wax/coat a truck there is. Done it this morning at 7am when it was 50 degrees with a 12mph south wind. I would venture a guess and say that is the last wax/coating I'll put on my truck till next spring.

 

Looks awesome! Considering the same. What setting are the coils on? How much of lift from stock?

 

Thanks again. Glad you're liking the new camera. I guess I didn't completely make my self clear. When I was asking about the 3rd gen I meant the camera , not your truck . I've seen a V1P and V1P 3rd gen and it looks like the top of the two cameras are different and I believe would require a different mount. I wasn't sure if the Shapeways dashcam to gopro mount you have would fit both, that's why I was asking. I want to use the gopro mount on the windshield and it may make a difference in what camera to get based on whether it will fit that mount with an attachment you got or not. The 3rd gen camera looks a little better but not sure how I can mount it if the attachment won't work that you got.

 

Thanks

 

I'm sure it is. I've just never taken anything apart on the inside of the truck like lots of other people have. May brave it at some point.

 

I paid about $200 more than Amazon but that was installed.

 

Omega AH300BLK 3 Bell Steel Train Horn (Black)

Omega AC15 12V 1.5 Gallon Air Compressor https://www.amazon.com/dp/B003GLOHTK/ref=cm_sw_r_cp_apa_i_0LibCbY06FSRS

 

Before the muffler