3rd Gen Magnetic Gray Thread

Hello, I like the way your headlights look in this picture. Is that a film or something on them or just the way the picture was taken?

 

It looks like the BHLM.

 

Replacing the needle bearing isn't that bad of a project. I actually enjoyed doing it.

It looks like you're in the PNW, check out the tool PNW tool library. There are some ECGS bearing puller tools floating around and other tools that will make the job easier.

https://www.tacomaworld.com/threads/pnw-tool-library.602410/

Good luck!

 

Stretchin her legs a bit this past weekend

 

Thank you! Ya I did the blhm, in the sun they look smoked

 

Muddy. but you’re the 2nd person to say that. I need to put that color in a can and make it permanent

 

I have watched the videos and it doesn’t look that difficult it’s just the idea of having do do it... LOL. I already went ahead and ordered a puller at the same time I ordered the bushing. I will likely loan it out or sell it after the install.

 

Amazon and TacomaBeast are the best places I've seen for lettering on the rear of the Taco.

 

One more from last weekends wheeling trip

 

Ha I just noticed this post.....theres about 500lbs of crap in the bed hence the lean

 

Dobinsons bumper powder coated to match MGM.

 

My 3 week old truck. Loving it so far. Downsized from a Silverado and Jeep Wrangler to this.

 

North GA a few weeks ago, tons of fun.

 

Great Pic!

 

Did you use your locker?

 

That doesn’t seem like a locker needed situation or even a 4lo IMO.

 

Busted out the snorkel actually

 

More an in general question about the trail, not the crossing.

 

Anyone got tips for cleaning the engine bay? Recommend products extra..

 

No worries, no locker on 4lo on this one. Just a good time