What Have You Done To Your 3rd Gen Today?

I’ve had that problem while working on my cousin’s Tundra. Dealership actually cross threaded 2 of the lugs on one wheel. Had to fight with it for 20 minutes then used a 2x6 board and a sledge hammer.

 

Not yet, unfortunately. Looks like a Kenwood, though.

 

I noticed my spiral cable has two unused pins. Is that enough to run paddle switches? I see three extra wires coming out in the Tundra thread.

 

I did not have any problems yet, changed over about 2 weeks ago (about 100 miles so far). Worked properly right after install. Got mine fr Amazon

Front Grille Garnish Radar Sensor Cover for Tacoma TRD PRO 2018 & 2019 TSS Sensor Cover

https://www.amazon.com/gp/product/B081N3HRGM/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1

 

Duh that’s why it lifts, reduces wind drag by giving the air somewhere to go. Especially good for side wind gusts at highway speeds.

 

Little help needed with a small taco switch...

I assume the colors match (please correct me if I'm wrong), but where does green go?

 

My dealership acts like it breaks their heart they don't get to hammer on my lug nuts when I tell them I already rotated my own tires. lol

 

ch4x4?

 

How would I know if it's a CH4x4?
I'm useless when it comes to this stuff.

It's this:
https://www.amazon.ca/gp/aw/d/B07QZPC9F1?psc=1&ref=ppx_pop_mob_b_asin_title

 

I put up a second one also. You can do it that way but one should go to the acc power (fuse tap) and the other to an illumination source. I’ll have to double check which, think green to the illumination. If someone answers or confirms before I do, great!

Edit; Red2 to illumination circuit

 

Damn, of course it would have several other colors and bad directions on wiring.

 

I’m GUESSING here but I would think Yellow = Red2. It’s possible it will be trial and error unless someone has used this switch. At least without having it on hand to disassemble or test. Black will be ground. One will go to relay, one to an illum source and one to a fuse tap. If that makes sense at all.

 

I'll take a wild guess and say green is ground.

 

get them done, @no vtec 4me
he has a page dedicated to them. https://www.tacomaworld.com/threads/retrofit-and-bhlm-headlights.565466/

 

Why is that your guess? I know in low voltage application green is ground, but typically with 12v applications it’s black.

Not to mention the description screen shot I posted only confirms black is neg pole and all others are positive.

Posted again for ref.


Considering most Chinese parts are similarly sourced and black is negative. I would guess Yellow=Red2, Green=Red1, Red=Green. It’s only an educated GUESS at best based off a couple assumptions and one known quantity.

 

Getting ready to stuff some meaty 30 inch tires. I hope I wont rub.

 

Swab the back of them (where it contacts the disc/drum) with some anti-sieze next time.

 

Looks like that’s San Onofre nuclear power plant. If that’s the plant you were referring to?

 

wish they had that when I was carrying around an atv

 

None so far. Not a single "error" message. And it is fully-operational. Been on for about a month or so. Only rain (and lots of it). No snow or ice (yet).