What Have You Done To Your 2nd Gen Tacoma Today?

Didn't do much put picked up fox 2.0s for the rear to match my kings that are coming

 

My wife thought the same thing when I baked mine. Lol

 

8-1/2” Top x 8-1/4” Bottom x 3-7/16” Height. Draw a rectangle find the center of the top (4-1/4”) and bring to the bottom. Measure 4-1/8” from the center line at the bottom and connect. That will give you the exact angle needed for the sides.

 

Have always hated digital clocks. I like the aesthetics of an analog clock. To answer your question, I guess 4 if you include the radio, my wrist watch, my phone and now this clock. Trying to buy more time as I get older.

 

Heck yeah. I like that.

 

Where did you tap in for voltage? Looks good.

 

Check the link in my sig buddy. Lots of info

 

What seatcovers are those?

 

So describe the engine improvement with the installed cam please.

 

Not too far from the 13th tee on the MCBH?

 

I ran it prior to the tune for a week, it felt as if I had more power low to mid speed, of course that is completely subjective and I have no data other than my butt.

As far as mpg improvements I have not finished tracking that yet will pipe in when I do.

 

Should've went with one of these, and they look much better than a hose clamp

 

ordered it a new midpipe with functional cats......

 

This wasn't today but last week I had a 24" (2 feet) installed on my truck. I'll have to go outside to get picks of it. Everyone is going to laugh about it but it was absolutely the size of lift I needed.

 

Wasn't today, but made a couple additions recently. With a new kid around, we realized we needed the truck bed for storage more often. I ordered a soft vinyl bed cover (Tonno pro) and put that on, and also finally got around to installing a pop-n-lock tailgate lock. Now the truck bed is a somewhat secure trunk area, and I have peace of mind knowing its much harder to steal my tailgate.

I'm planning a bed mat to keep things from sliding around. I am also thinking of making some sort of organizer to keep things nice and neat in there.

 

I went almost 12 years without one and I had these laying around so I figured I’d use it .

 

Most feel the power in the low to mid range of the rpm. Data logs showed about a 30 hp gain on my engine at redline (highly modified engine). Most get about a 1mpg gain over where they were with or without the tune to go with it. Truck will feel smoother at idle. Dont take my word for it (the guy selling them) Check out some of the reviews from others that have purchased them following the cam gear link in my sig

 

Turd gen bed mat same as 2nd gen?

 

Believe so! If I remember correctly I got mine from a guy who had a third gen.(dcsb)

 

I had a shop finish what I started. I went to bleed the brakes and the passenger side rear bleeder valve turned into an issue. Stopped turning just a little bit opened and I couldn't turn it either way with a set of vice grips after stripping it. Wouldn't unscrew to replace and wouldn't close to stop the bleed of brake fluid. I stopped so I didn't damage the cylinder and went to a shop. The shop was able to extract the bleeder valve and bleed the brakes for me without replacing the cylinder. Fun.