What Have You Done To Your 3rd Gen Today?

Just the bulbs

 

Had to buy mine on eBay

 

Finished up a switchpro setup for a member

Then decided to make myself a new Mount and was able to find paint pretty similar to cement

 

Which LED plate lights did you get? I just ordered the runnin4tacos ones yesterday and now wondering if I should have...

 

AJT Designs - temperature control knob rings (Before)


AJT Designs - temperature control knob rings (After)

 

I had a Westin bull bar with a 20 inch light on mine. I didn't care for it (came on truck when I bought it). Personally not a fan of bull bars. I took it off and replaced it with a full grill guard. But I like that one on your truck. But I'm already in the hole with grill guard, so it stays

 

Did the same last spring. Bought mine at Autozone. So far I haven't had any issues. But yeah, getting them back into place required me to say more than few choice words (aloud and under my breath). I also installed some on my reverse lights and have an LED light bar just below the tailgate. It's bright as all get out when I put in reverse and see the image in the camera.

 

Installed black vinyl wheel decals from SimplyMuggle. Best $34 ever spent.

 

How hard were these to install? I've been eyeing these, but wasn't too sure about the install.

 

I agree!

 

I need to find some for my SR5 wheels, but so far no luck.

 

I just installed some on my 2020. Super simple, and they give me the added lift I wanted! Power seat didn’t go far enough up in front for me, but now I’ve only got it raised partially in front.

If you can turn a wrench to loosen, remove, and replace a couple of nuts, you can do it!

 

Rims on the orange need to be on the white IMHO. But both look very sharp!

 

Just got the taco back from toyota. P0303 cylinder#3 misfire.

 

What year is your truck?

 

Dude! That’s just wrong!
You cannot tell us you found something similar to cement, and not tell us what it is. BTW, nice bracket and work on the switchpro.

 

Wasn't Madrigal the German chemical company from breaking bad that they stole the methyl amine from?

EDIT: Shit, I hope posting that doesn’t put me on another watch list. :/

 

They only make decals for wheels with machined silver accents. It would probably be too hard to cover an entire wheel with vinyl. I actually like the look of sr5 wheels the best if they're painted or powder coated black.

Edit:
Check out this thread if you want to try painting your wheels.
https://www.tacomaworld.com/threads/step-by-step-trd-wheel-paint-project.553263/

 

2017. It threw a cylinder #3 code and my truck is has 59,700 miles. So i thought it need new plugs. So i bought one plug for the #3 cylinder and i didnt work. So i took it in and it was in the shop for a week and a half.