Need pic of bed from 2nd gen long bed

*** BEFORE I GET BLASTED FOR BEING A LAZY-ASS - Cannot complete this task due to recovering from L4 and L5 lower back surgery.

I would like to ask for someone to help me out. I have a 2006 Taco with a long bed, full size spare tire carrier, and hard tonneau cover - I am looking to see if someone with a second gen Taco with a LONG BED, and no restrictions at all, could post a good picture of the whole bed unrestricted. Preferably close enough to were you can see all the ribs on the bed, and far enough to were you see only the bed. Not interested in seeing the cab or anything else, just bed, bed rails, and wheel wells.

Preferably from above looking down. Kinda unusual request, but it would help me out tremendously on something I'm looking to do in the near future. I figure ask for help since I am not able to move freely and carry ANY heavy stuff right now...

Anyway, I hope someone here can assist.

Thanks!

Rick.

 

I have an 05 ACLB and I can help, but I can't clean all the shit out until tomorrow, I'm sorry!

 

Thanks for the offer, no worries.

 

you have my interest. Unfortunately have a short bed, but what is it that you are trying to acomplish?

 

Well, right now, trying to find some exact dimensions as well as the contours of the bed. Specially forward of the wheel wells.

 

Do you need measurements too? I have a LB with a bed rack over it. Is the rack being there a deal breaker for the picture?

 

2006 access cab xrunner 6feet bed

 

The following thread might help.

2nd & 3rd Gen Detailed 6ft Bed Dimensions

 

Thank you very much!!!

 

Thank you!

 

Thanks, but the measurements are not necessary since in can easily get those here in TW. I need a picture of what the bed looks like, if this makes sense.

 

I’m confused. You got a picture and you got dimensions/measurements... what else are you looking for?
I have a long bed with a trifold cover and rails. I’d like to help but not sure what you’re asking for...

 

Spill it. What's your plan? 3-D printed bed-liner? Triple-decker RTT? Dog kennel? Pie racks? Fuller Brush Man? What's in the works?

 

Maybe he's trying to size a toolbox to fit between the wheel wells and header rail? That's what I ended up doing.