What Have You Done To Your 3rd Gen Today?

I wish I had this many friends with Tacomas... Shit, I wish I had this many friends..

 

Don't feel like you're beating a dead horse. It's no joke when a recovery point fails.

At least yours rated so you know what it can do with it. I was looking at that over the cosmetic ones until I got lucky and found an ARB for cheap that someone couldn't use with their bumper setup.

• 8250 lb rating**

 

That is why I have the BPF. It is also rated and is frame mounted. Symmetry of the 2 hooks looks better but if snatch or get snatched I want something worthy. Try snatching the cosmetic ones and someone might get hurt.

 

Yes, as it is attached to the cross member and the OEM one was removed bolted to the same area.

 

Put my overlay on the 4x4 emblem, think it looks good with my tailgate inserts. Debating on swapping the factory chrome tip for a factory black tip to go along with my color theme, as of now my truck has only 4 peices of chrome (excluding the headlights)

 

Not to bothered by the chrome but dig the nap

 

The Kruiser is awesome, but I got a new improved tune out now.
New KDMAX Performance Tune by @PapaRee and @TWtaco | Page 15 | Tacoma World

 

I know what you mean. If I could have found a tire in a 16 that had the same cross section and height as the 285/75R17, I would have gone that route.

One of my biggest justifications was that, wheel diameter is going up 1", but so was tire diameter, so essentially same amount of sidewall as before. (technically 3mm less, I'll sleep ok)

 

John was talking to me about it. I decided on the Kruizer for now just since its been out for a while and I liked that it has been a bit more tried and true. Maybe when he is back in the burgh again I may upgrade to the KDMAX but I am pretty happy how the 4.0 woke up the truck.

 

Ordered the Tom Woods 1 peice driveshaft, to replace the oem trash.

 

Interesting, why did you replace it?

 

Thanks for the coupon REI!

 

Rear seat delete is delivered tomorrow. Soni removed everything today. Fyi, that little circular part that says "air bag" on it, above the rest seat belts.....Pull the top back a bit of the trim, then slid a finger behind it and it in pops out. Took me forever to discover trick.
The new electric impact wrench was awesome to have to use. But I still ended up hurting myself, bleeding my own blood. Not horrible, just some knuckle skin.

 

10bucks overlay from Amazon


Now I need figure out how to install 4x4 piece.

 

****SOLVED****

SHOUT OUT TO @mokeiko !!! Thanks Again For Your Help!

I was able to fix them, I'm a happy camper now. I checked the low beam fuses mokeiko pointed out (that I didn't realize were there) and they were fine, but after looking at them in the diagram on the fuse box lid, the ones he pointed out say H-LP LH-LO & H-LP RH-LO and I noticed just above that there is a 15 amp fuse that says H-LP LO so I pulled that one and surenuff it was blown, replaced it and we're all good.


So just to recap I have highlighted all of the headlight fuses, should anyone have this same issue in the future - I hope this post will find you.

 

Spotter Mirrors and registration. Check!

 

Thanks!

 

Yeah, still playing catch up and drooling over things

 

Damn, didn't you cut off your foot or something last week?