What Have You Done To Your 3rd Gen Today?

I did front and rear at the same time so it’s hard to isolate how much of the improvement is the rears. I’m very happy with the improvement they both made.

 

Installed auxbeam 8 switch panel. Super clean install and this unit is affordable!

 

Home made rear seat delete

 

Well hell.

 

Looks pretty good for a $107 “lift”
May have to consider this for mine.

 

https://youtu.be/LM-eOlCIwiU

try this video, it covers how to cleanly run the wire into the fuse box.

 

Another quick and easy mod, for fun.

 

Newbie here.

Got rid of the cow catcher, SIMPIN it up with a pro grill, installed kicker speakers, tossed on a tonneau cover and have a rear deck drying and ready to toss In Hopefully tomorrow

also have a pioneer head unit I’ll try to get to tomorrow then window tint this weekend.

 

@Puppypunter can make you an SR trim level conversion harness for the factory LED headlights.

https://www.tacomaworld.com/threads/sr-sr5-oem-led-headlight-conversion-harnesses.720866/

 

Started the seat heater harness (drivers side) install. I redid the harness length and connectors (on-site finalized) and removed the broken panel on inner seat so I didn’t have to remove the seat again. Maybe tomorrow I’ll get the rest ran up to the overhead

 

You have anything else running in the back? How’s the ride?

 

Good episode. Glad you’re safe.

 

Installed the AVS Hood Protector. I think it compliments the Prinsu. I actually had a tiny rock chip already in 16K miles, so hopefully the avs will be funtional as well.

 

Hope it works well. I’ve been considering this too after getting a decent sized rock chip in the first 10k.

 

Hopping into this would make me feel like we're about to air drop into a Central-American jungle to hunt The Predator.

 

Thank you, very much appreciated!
I'll try this as soon as my replacement is delivered.

 

Very low profile, I like it. Does it bugger up the rubber seal between grill and hood ?, how involved was the install?, thanks

 

Question- does the upper row of MH screws sit flush/recessed or proud of the surface?

 

I have the larger bug deflector and it’s been doing it’s job at protecting my hood from rock chips. However if you think a couple of chips in the goods bad after a few thousand miles just frigging wait till you see what your bedside’s look like after 80K... my rear fender flares look like they have bad acne and there’s quite a few little dings all around the box sides. I’m on stock wheels, stock width tires and I still have all my OEM mud-flaps surprisingly, it’s about 50/50 on road vs off road miles though. I couldn’t imagine what the truck would look like with a wider stance.

 

The fit was almost perfect. It uses 3M auto grade doublesided tape, so you just expose small areas or tape, position it, then pull your tape tabs and apply pressure to help the bond. AVS includes a prep solution to use first, guessing it eats wax and surface contaminents that might keep it from sticking. Fairly simple install maybe a 2 out of 10 in difficulty (for me). 1/10 if you are mechanically inclined.
I really do like the low profile. Honestly, It's more for looks but i'm hoping it may save a few nicks and chips on the hood.

edit.. where it meets the rubber seal, it seemed to fit great.

linkage..

$100 Auto Ventshade [AVS] Aeroskin Hood Protector | Fits 2016 - 2023 Toyota Tacoma | Low Profile Deflector / Bug Shield - 1 pc., Matte Black | 377079

https://www.amazon.com/gp/product/B01BYJHSQO?ie=UTF8