Can you install Lamin-x without taking fogs out?

Is this possible? Because when I try to take my fogs out, it feels as if the bottom is screwed on or something. I know that there are two things that hold it on the right and left, but when I get them free, the bottom holds down. So, that's why I'm asking if I can just directly clean the fogs and apply them while they're in? Mahalo

 

i did it witha hair dryer

 

is the lamin-x better than painting then yellow and where would one buy lamin-x

 

i just took my fogs out to smoke them and if you look at the bottom screw theres a little dial behind it(same one in your headlights to adjust them up/down, left/right) its just smaller, thers a rubber thing and inside it theres a screw which connects to that little dial, not sure if im making sense but just take that screw out and the dial will spin and once thats completely loose, the two side tabs will slide out too and just push it out, same way with the install

 

I did mine without taking them out... took about 5 minutes and I used a heat gun and my thumb...

 

laminx is 2-3x the price. Its no better or worse. I painted, and glad I did.

 

i used the laminex.. left them in and just applied it without any heat.. did it when it was about 32 degrees and it still sticks fine a couple months later.. but im not very happy with how they look.. i bought the paint and im gonna peel them off and paint it

 

no need to take the lights off. did mine in like 10 min total. just go slow use your thumb and a x-acto knife. if you mess up u have like 48 hrs to fix em just peel and restick.

http://www.tacomaworld.com/forum/lighting/36626-how-install-lamin-x-fog-light-covers.html

 

I did lamin-x while they were in, its kind of a pain in the ass to do. I'm not happy with them and will be ripping them off and getting the yellow paint instead.