3.4 oil filter relocation(2000)

I have installed a few of these most use a PHA8 filter.

Does any know of a relocation kit that can use the Toyota Filters or a means to source the parts to build everything myself.

I just started looking into use of the Toyota Filters.

Thanks

 

I had thought some one Ha Ha Ha might have done it and knew some real world numbers.

I have one on the shelf that uses the Fram PH8A.

I was hoping to limit the different filters to Toyota or Ford.

 

I don't know of an application specific kit for Tacomas but I have an oil filter relocator. The PO installed it, I didn't like the way it was done so I redid it. I use stock size oil filters. Well stock dia & thread size, I'm using D3 filters, in the past I was using OEM size Mobil1 filters.

Pics in the following link, still using the same mounts but no more teflon tape. I don't recommend teflon tape, will start to slowly leak after a few years. Last time replaced the hoses I used Loctite 565 thread sealant, no more leaks. Still need to swap out the worm clamps with spring clamps now that I got some, next hose change is when I'll do that.
https://www.tacomaworld.com/threads/remote-oil-filter-kit.120695/#post-2329777

Unfortunately I don't remember the P/N I used for the oil filter relocator mount when I got the new one. The one I used is made by Permacool & I got it from Summit. The prev one & the filter adapter were Permacool also. I just choose the configuration I wanted for the location I have it mounted with the stock oil filter thread size. 3/4"-16 IIRC but don't quote me on that.

If you do decide to install one, pick up extra o-orings for the filter adapter (that screws on the stock location) & keep extra hose on hand (be sure to get trans cooler hose). The oring & hoses don't need to be replaced often but of course once they get old & hard you'll want to change them out. And again, don't use teflon tape.

Found some more old pics but doesn't look like there are P/Ns on them. I could of sworn I posted the P/Ns somewhere here for the parts I'm using but my search came up empty.

 

Just looked on Permacool's site, for the record (and for me), this is what it looks like I'm using.

#111 3/4"-16 Filter Adapter

#1701 3/4"-16 Left Mount Remote Filter Mount (My old one was #1211)
(Different mounts available, depends on where you want to mount yours)

Filter adapter O-ring size -230 (2-1/2"x2-3/4"x1/8")
1/2" NPT ports. 1/2" ID hose

 

Looks like PH8A is 3/4"-16. So if you already have one it should work with a Toyota filter.

 

Thanks for posting it was a great Help!!