Hey Connecticut, our everything hurts

Amazon of course
It's the MPOW that @vssman has it appears

 

Cool. Thank you Sir!

 

Same here in New Yorkistan.

 

Working on @CTSpruceMica next car?

 

Saw a silver one at Lexus of Mt Kisco today (was there getting my last free oil change), aaaand the dealership owner's LFA was in the showroom

 

Oh HELL NO!!!!!!!!!!!!!



The only car that would ever replace my 911....is another 911

 

Hondo's Garage. Pricey but excellent. https://hondogarage.com/products/toyota-tacoma-phone-mounting-system

Will mount on any vent in the Tacoma. Fits 2016 plus model years.

 

Thank you Sir. I'll have to check it out and see what they have for the 2nd gen then.

 

Oh I like that holder.

 

@Cativelense https://www.scosche.com/stuckup-window-vent-mounting-kit

I have used it with great results. I suction cup it to the bottom of the window dead center and curve it to follow the contour of the dash then it rest just over the center left a/c vent. It also has a vent mounting kit in the box to use. I purchased mine at Bestbuy.

Suction cup seen here with completely irrelevant car with a Huge rear spoiler for a 50hp boost.

 

Good morning CT. Happy Friday Eve.
Went to bed stupid early because my shoulders and legs were killing me.

I did start wiring the compressor on lunch. I was supposed to get the switch bracket yesterday which would have helped this install along but now Amazon says it may be today or tomorrow.
My other orders showed up except for the one thing I actually needed. I need to know the position of the switch so I can wire the relay.

 

Morning everyone.

Happy Friday eve.

 

Morning all

 

Almost friday- woo!

Nuno- this is mine. Absolutely solid, even while bouncing through trails.

 

I like that... A LOT!

Where did you get it, if you don't mind me asking?

 

Amazon for the Ram Mount parts. Hardware store for the hardware. Tacomaworld for the idea.

https://www.amazon.com/stores/RAMMounts/Homepage/page/46B7427E-6C9D-48FB-ACEE-C3973B91DD65

https://www.tacomaworld.com/threads/mod-a-pillar-ram-mount-gps-phone-holder.372250/

 

SHIET!!!!!!!!!!!!

I might have to do that then. That looks like a bad ass set up.

Thanks a lot Mike.

 

Tip of the day?
Don’t let a body shop fix your wiring.

 

I can't tell you how many times I've seen the "twist the wires together and tape them it'll be fine" on the job, sometimes the tape is duct tape too....

 

This was crimp, solder and twist/tape, all within 6 inches and the sensor was installed upside down making the low washer warning message appear