Colorado Trading Post

Me too. Literally only have a FB account for marketplace.

 

yes - it is a better product than I had on my '16 TRDOR AT V6 with SC.

 

Not mine:

1st gen short bed GREEN Snugtop. CHEAP $200
Missing back window, but it's easy to get a replacement from Snugtop. Downside is that the replacement glass, hinges, latches are probably like $500.

Still, if you're looking for a green one, this is probably the best price you'll find.

 

SiruisXM receiver $20 in Arvada

 

FOR SALE - $250 Ekstrom Design/Coachbuilder +1 Shackles. Brand new, never installed. (for 2nd Gen Tundra)

 

FOR SALE - Revo x Bode Miller Ripper #10 Goggles - $99

Used 1 or 2x but were too large for my face. Excellent Goggles in Excellent Condition. Never change a lens! FIT SIZE LARGE

Experience revolutionary visual clarity with Revo's Solar Orange SuperNova+ photochromic lens technology that automatically adjusts to changing light conditions while blocking glare. Whether you're carving through powder or navigating challenging terrains, these goggles ensure optimal visibility and protection. Bode Miller tested and approved.

 

FOR SALE - Rockymounts Monorail 2" Hitch Rack - $350 It has a couple bumps & scrapes, but everything is solid working order. It's a solid rack. Includes the upgraded metal keyed locks for the hitch pin & the cable lock w/ 2 or 3 keys.

 

FOR SALE - LIQUID LOGIC REMIX XP9 & XP10 Kayaks; These are LL crossover boats suitable for white water or flat water paddling with the drop skeg to keep you straight and a decent rear hatch for gear. Both have been stored inside out of the sun for the entire lives.

I have good neoprene spray skirts for both I will sell for an additional cost.

REMIX XP9 - $500; Used this boat a lot, typical bottom scrapes but tons of life left in her. "Custom" Cup Holder; includes paddle.




REMIX XP10 - $800; This boat literally has seen the water about 5 times and the hull shows it. Same features as above in a longer length. Drop Skeg, hatch, etc. Also will come with paddle.

 

My topper is officially for sale. It's an ARE for a 6ft bed 3rd gen. Back and side windows flip up. Front window flips down. I added custom bug netting to the side windows, and a latch catch for the front window to prop it open slightly in cold weather. All the mods can be easily removed if desired.

It's in good condition with few tiny chips around the bottom edge. I just replaced the seal with an ESI triple bulb seal. And I just replaced the gas struts on the rear window. Asking $1000.

@TacoTimbo can probably paint it for you if you want a different color.








Front window catch: https://www.tacomaworld.com/threads...3rd-gen-today.399305/page-14063#post-29870172

Bug screens: https://www.tacomaworld.com/threads...3rd-gen-today.399305/page-14063#post-29869779

 

Letting go of a MTB Front Wheel mount thingy for Toyota bed rails. Reference this thread

The mount supports 15mm x 100/110mm TA front hubs. Used a few times but no longer have a use for the thingy. Asking $40 for OG mount and bolts. For an extra $10 I can provide a 9/16" thick Aluminum Block Spacer and longer bolts to allow mounting the wheel thingy to work with a Topper.

 

I have two awning that I am pulling off the truck, both in pretty good shape, both covers have some tears but are sealed up from any weather, small hole in one but taped and as seen in photo. Yakima slim shady small hole but taped 77”x77” and a Roam Size 4’ both have ground stakes and bolts,no bracket, asking $50 each, Located In Longmont

 

NM: $100 neoprene 1st gen seat covers. I wouldn’t worry too much about the stains - I bought a used set for my 2nd gen that was similar and after soaking in the bathtub with warm water and scrubbing some with some soap, they looked almost like new.

https://www.tacomaworld.com/threads/100-coverking-neoprene-seat-covers.854990/

 

SOLD

 

**SOLD **

 

I have 1 extra Loveland lift ticket. Valid this season only, came from a 4-pack.

$40, pickup in West Greeley.

 

Not Mine:

1st gen DCSB fiberglass tonneau $250 in FoCo.

 

Not Mine:

1st gen DCSB ARE mid-rise fiberglass shell WITH rear "camper" door (replaces tailgate). $1900 is a bit steep unless you REALLY want this specific one. Gold color.

 

JACKPOT. Not Mine.

$150 including round bar roof rack with rails. White 1st gen DCSB shell. Looks to be an ARE. Up in Cheyenne.

 

Interested! DM'd you!

 

Hand pump for RV sink. Brand New, never used. Pumps on both strokes from holding tank, or can be used with city pressure (requires pressure reducer, not included) by simply pushing handle down.

Perfect for that overland build, wedge tent, outdoor kitchen, etc...

Around $50 new, first $5.00 takes it. Come get it.