Ammo Can tool box mod

http://www.tacomaworld.com/forum/2nd-gen-tacomas/114001-bed-rails-attachments.html

this is one of the link i used. i don't think i have the other links. i will check my other computer later.

 

It may have been asked, but any pictures of the actual mount and how you did it?

 

unfortunately i never took pictures of mounting them, but there are 2 bolt in the side of the box with a washer and a strut channel nut with the spring cut down in bed track system.

 

I am soooo doing this. I have 4 cans empty in the garage!!! I wouldn't necro-post, normally, but being as I am a totally excited, new Tacoma owner...I just had too.

If anyone has pics of the rail mounting, that would be a help.

Thanks

 

sup. doing this with in the next week. OP how many bots are holding it to the bed rail, 2 or 3?

i’m going tomorrow to bed bolts for this and fishing rod holders.

 

2 bolts be ware they will rattle

 

ok thanks. i’m also going to add some rubber to the inside to cut down on stuff moving around.

 

Take a bolt and 2 nuts drill a hole in the middle of the side that will be against the side of the bed so support the bottom of the box this way it wont twist and rattle by hitting the bed.

 

ok thanks! so you added 2 on the bottom? they just keep it from hitting bed? not holding the box right?

 

I have actually taken them out when I got a bed cover. But I had a small block of wood but a bolt or 2 to keep it from rattling plus then u can adjust it as needed

 

all the photos r gone