FS-MA Universal Homelink Garage Door openers

All SOLD for now, thanks!

I have a few Universal Homelink Garage door openers, they can easily be installed in any vehicle.
Here is a thread created by El Tano that shows the easy installation in a Tacoma-
http://www.tacomaworld.com/forum/2n...nstall-homelink-garage-opener-w-pictures.html

I have the following for sale-
9 Gray- 8 sold
2 Black- 2 sold
1 Tan- sold

*I will sell them according to the order in which I receive PM's

$22 shipped/paypaled via usps priority mail, please send the funds as a gift to avoid fees, otherwise you pay the extra 4%
I'm also located in Worcester, MA for anyone local.
Thanks,
Mike

 

Tell your friends and spread the word on other forums, these can be installed in any car!

Thanks,
Mike

 

bump, one sold, and a couple pending, all colors still available!!

 

rolling code?

 

PM sent.

Free Bump.

 

yes, these are pretty universal, here's how to program them-

To program a built-in-car transmitter to a rolling code garage door opener, you should take the following steps.

1-Clear out anything previously programmed into the in-car system from the factory by holding down on the 2-outside buttons simultaneously, until the in-car LED starts flashing rapidly. This may take up to a minute (in most cases, the key should be on auxilary, and/or the car door must be shut).

2-Decide which button you want to make to be your in-car garage door transmitter. Hold your transmitter up near the selected button, pressing both the garage door remote and the selected in-car transmitter button simultaneously. Hold down on the buttons until the in-car, LED light flashes rapidly. This sets the in-car remote transmitter to be your garage door openers make transmitter, but you are not done. You now need to make this in-car transmitter your personal transmitter.

3-Go to the Learn Button on your garage door opener. The button is usually next to the area where the floppy antenna is connected to the motor head. With Genie it is most often behind the light lens, and an indicator light flashes red when pressed. With Sears or Liftmaster (Chamberlain) it is near, or part of, the terminal screw board, and is a red, green or purple square button with a green, amber or purple indicator light. Press this learn button momentarily. The indicator light will turn on and blink if Genie or otherwise stay lit. For Genie systems, go back to the in-car transmitter button you programmed and press this button 3 or 4 times, or until the door starts moving. This should set your in-car transmitter to your garage door opener. For Liftmaster, Sears, or Linear Megacode press and hold the in-car button you programmed until the garage opener light flashes. Your in-car is now programmed to operate your door.

 

4 sold, a bunch more to go!

 

Get on these folks...I love mine and it was SUPER EASY to install!

 

PM'd

 

Thanks for the bump, it looks great!!

 

friday bump

 

PM sent

ETA: Paypal sent for 3 gray ones.

 

ONLY 1 of each color left!!

 

bump please

 

dude these are BAD ASS!! I kept seeing them pop up and never clicked to see what they actally were. Nice. Pm Inbound GOod SIR

 

PM Sent - I'll take the black one if it's still available.

 

Free bump - Payment Sent

 

Do you still have any of these?

I call a tan one when you stock back up!

 

Super cheap price!!

 

I would like a gray one if you get more...... let me know