What Have You Done To Your 2nd Gen Tacoma Today?

Took off front mud flaps, and hosed off all the salt.

 

Installed Andres Devil Horns thanks to wildjerseyfirefighter (Joe) who sold me his. http://www.tacomaworld.com/forum/2nd-gen-builds/250234-toyohtadudes-build.html#post6232363

Also put in new wiper inserts, new cabin filter and fixed the air-intake vibration with some rubber weather stripping. Yea!

 

Gave the keys to my daughter cause her alt a bearing last night.

 

Be prepared to be hosing some more.

 

I know, but almost ripped them off twice backing up in snow. . Would rather hose off the salt.

 

Changed oil using Castrol Edge and OEM filter. Bought a piece of 5/16 plastic tubing I read about. Easiest change i ever did. Drive a lot of short trips of just a couple miles. Hope synthetic lube helps mileage, etc.

 

Mounted an ammo can to my bed rail. Next is to do the other side and to find stuff to go in the cans!

 

I hopefully improved my sucking power...

 

Took out the K&N filter to clean and re-oil it, cleaned the MAF sensor and throttle body. I think I did the MAF and throttle body a year ago or so and the throttle body was fairly clean this time.

 

I hear You can get Jasmine to change those and make dinner after...

 

I did this.

 

installed the front set of covercraft seat savers i bought in june or july.
rears will go on tomorrow.
i procrastinate badly.

 

Pulled out my left rear axle. The bearing is DUST. Gear lube all over the brake shoes, drum, wheel, I think I might need a seal and bearing assy. Ya think? Going to the press tomorrow to finish her up. {

 

Go ahead and replace the seal while it is apart.

 

Front valence^^




Axe/shovel mount. I'll repaint the orange an red later tomorrow

 

got it dirty