Factory rake after 3" lift

I'm looking for advice/options to get a factory rake (rear high) look.
I recently installed Toytec-TTHA-CK 3" lift kit, 5100's all around with 620 Eibach springs up front set at .85, TSB 1 1/2" AAL w/2.5 degree axle shims. As she sits now its pretty much level to the eye. When you measure, its approximately 1/2" higher in the rear. Whats my best option to achieve more "rear high" rake?

Will the new 5100's I just installed in the rear be long enough if I go any higher in the rear? The new 5100's that came in the kit are listed as "extended length 5100's".....

1. New leaf pack? (I like the Dakars)
2 Rear block 1/2"-1" to join the AAL?
3 Other option?

This is my daily driver and I do not go off road. Im hoping to not replace the new rear shocks, as these are 3 weeks old. But I will if needed.
Thanks in advance

 

I'd put the Dakars on. I've got the Toytec ultimate lift kit with the dakars and don't like it because i can't level my truck up. The Dakars will give you every bit of 3" or more in the rear. I do have the extended travle rear shoks though. Should have just put a Pro Comp 6" lift on and been done with it..lol

 

What is your hub to fender measurement currently? Compare it to the numbers in this thread and you will know if Dakars are your answer

http://www.tacomaworld.com/forum/suspension/173193-2nd-gen-ome-dakar-hub-fender-measurements.html