Oahu Members Thread

BTW, thanks to everyone who bought a trailer harness relocation bracket.
Brandon, I hope you fixed that seized s/s screw... sorry about that
Chris, I will have your modified version ready Wednesday. I will also have 2 more brackets if anybody else wants them. Otherwise it will go into the for sale section.
I have also been making small runs of aluminum bed rail slot nuts. If you guys need to mount anything to your bed rails, let me know.
Thanks again guys

 

I like the bed rail mounts can those be used as extra tie down on the rails? I would like a couple bike fork mounts if can lmk info on them thanks

 

I was thinking of your situation, and another scenario that I was pondering was your motor mounts. If your engine is rocking under load, maybe its pulling on the pipe to the airbox pulling the filter off... Just a thought, hopefully you got it settled already.

 

Just got in the toytec ones, but they may not be long enough for your application. They measure at 23"

I don't know about the homemade goodridge lines, but I ran the company's one on my G35 and they were good, run speiglers on my bike. Just wanted to try the toytecs, teflon lines, 5 layer steel braid, Kevlar reinforced, and come with clips. The fronts are backordered and will ship out to me later. Quality looks okay from what I can see. I'll be waiting to install em all one time.

Allpro makes one for 4" of lift, but they ship ups and its a huge price difference. You could use them and put a spacer under the hard line bracket, raising it up a little. Or try 4whel parts, they have extended lines in stock, may be what you need. GL!

 

I have the AllPro front & rear. I like them .

 

Just tossed this up in the CL section. Thought I would copy it here

 

How about you give that $100 to me and I'll install the lift for you?

 

still have one left over?

 

definitely down for that!! ill have it at the end of the month.

 

The fork mounts are rocky mounts 9mm clutch. The can be found for about $25. The slot nuts I make are very strong, and I can tap them for any size bolt.

I'll save one for you luka. $30 with all the hardware for the local boys.

 

awesome thanks!

 

Shoots can I get some for the bike mounts? And also a trailer relocation bracket?lmk thanks you can pm me

 

yeah see the only one im conserned about is my e-brake. because i think my lift kit came with extended brake lines... but im really not sure i gotta look again. i may need u to take a look when u get back from TX. did u extend ur ebrake line too??? or how does that even work

 

wasn't the motor mounts. had one of my friends at work hop in my truck and redline it a few times to see how much my engine shook... maybe 1cm at best that motor is solid. But its fixed now for good. doubt it will ever fall off again. i literally had it maybe finger tight before because of the limited tools and the angles i was working with.

yeah im gunna look into those, thanks for the help guys!

 

Compressor hose is spoken for

 

how aboot them lights nate

 

I didn't do much with my e-brake lines, I cleaned up the orientation of the brackets on the leaf spring but that was about it. It runs along the leaf springs so you'd have to check your slack. I have around 4.5-5in of lift in the rear and mine are ok.

 

that's a great deal, i'd even pay it

 

yeah i was thinking that maybe i just need to add a few inches to the mounting bracket... pretty sure it should be long enough for what i need but i dunno yet.

 

I just "aligned" my current bracket a tiny bit with a deadblow. You might be ok.