Modify Bench Seat????

Has anyone successfully made it where there bench seat will recline a little more back??? If so could somebody share how they done it or a link to a write up???

Thank you

D. Miller

 

Here ya go....

http://www.tacomaworld.com/forum/4-cylinder/170862-changing-angle-bench-seat.html

 

Thank you!!! +1 coming your way!!!

 

Thought I'd share how I done this:

I used a 14mm socket and ratchet,
Die grinder with burr bit
Screwdriver-phillips



First I took of the plastic side panels(2 screws on each)



Then I took out the front bolt and loosen the rear bolt



I also left my seat where I like it so once I took both sides out, I let it rest against the back of cab, then I used my burr bit and made the hole bigger.



Used a magnet to pick up shavings.



Put bolts back in, tightened them all up and now I have a gangster lean with my bench seat!!!



Took about 20 min. I didn't take seat out, and if you wanna put back to factory all you have to do is move the seat back to the original spot. Hope this helps somebody!!!

 

I think this is the easier way.

http://www.tacomaworld.com/forum/2n...h-seat-recline-yes-there-way.html#post7492053

 

Where did you get those seat covers? It looks like they fit real nice on the bench seat.

 

Wet Olkie's

 

Thanks