Illumination Supply Light Bar + BAMF Light Bar Mount GROUP BUY

I'm totally down for buying the 20", Double row, Combo..............but after the 1st of the month, b/c I have to see where $$ is. Bills come first. This is too good of a deal to pass up.

 

Can I order different mounts?

I am looking for something like this to use to mount.



Or do you know if these types of mounts will work, if I can find them?

 

Yup, they're removable:

Unfortunately those mounts won't work with these light bars. These mounts were for the gen 1 single rows.

 

Oh, I see. Thanks.

 

30" single row (combo) with single harness

 

Dumb question.
I'm assuming the light bars come with all wiring necessary (specifically the relay) aside from the harness/switch. Thanks

 

They're not included with the light bars but are sold separately for a small cost. The wiring kits they sell have the relay and switch included.

See the bottom of the first post: http://www.tacomaworld.com/forum/gr...mf-light-bar-mount-group-buy.html#post7542153

 

Per the OP I believe it's like a 10 to 15 dollar extra for the harness setup.

 

ok thanks. I ordered the double harness, just wanted to make sure one of those has the relay. I don't want to have to go out and get another piece and everything is there for a complete install. Couldn't see the relay in the picture of the harness.

Thanks again

 

You may want to still double check with the OP to make sure but in this post, a user posted a picture of what I believe is the same wiring harness the OP is selling. In the picture you see the necessary inline fuse and relay connected.

http://www.tacomaworld.com/forum/gr...-light-bar-mount-group-buy-8.html#post7608424

 

It's got everything you need to wire up the lights.

However, the one thing you'll want to do is replace the switch. Look back through the thread for some help with what switch and how to swap it.

 

I fully support moving it till after payday (the 1st).

I /can/ afford a new bar, but the /should/ leaves me on the fence.

 

I am fine with waiting a few days too.

 

yup. i wired in my own switch, and mounted it

 

Please put me down for a 40" double row combo and a single wiring harness

Thanks!

 

what kind of switch did you use?


Im so close to pulling the trigger..........

 

There was a guy selling switches in the second gen for sale board. I used his.

 

Do you have a link?


I was thinking about using this:

http://www.ebay.com/itm/TOYOTA-FOG-...NDRA-CAMRY-PU-RAV4-LAND-CRUISER-/171154560825

any idea it it would work?

 

What the heck sign me up, double row, 30'', single harness, and combo.

 

Screw it. Im in for a 30" Double Row, Combo pattern. Single Harness. 2 pin Deutsch Connector (Female) as well.