What Have You Done To Your 2nd Gen Tacoma Today?

Ordered pair of d-rings for the bed bolts, weather tech bug shield & floor mats. Dealer applied perma plate to the paint yesterday.

 

Where is this going?

 

Not my truck but in the same spot.

 

What are you going to do with the small gaps on each side? I also have one of these from the TW member with the same thought, just haven't decided how to fill the gaps...

 

Looks good! What's the reverse light mod?

 

Not sure been kicking around idea's on what to do.

 

what i used:

large zip ties
roll of paded insulator tape or anything to dampen loose wires against plastic panels

the large engine harness wire on the bottom of the dash by your passenger feet, i zipped the hell out of those wires to nearby brackets to prevent any movement as well as applied some padded tape in between the harness and other wires behind the glovebox (you will see it when you remove the glovebox) and applied two small strips behind the upper plastic panel behind the bold where the glove latch is. You will tell where there are two points where is possible contact with some dash wire in front of the metal tubular dash support by the airbag.

 

Thanks. I'll take a look this weekend and see if this is the source of my rattle. I think it might be a little bit higher in the dash but this is worth a shot especially if it gets rid of it.

 

^ i thought the same thing but i read that a lot of people solved it from the engine harness so i gave it a shot

also there is also a clear whitish bracket that mounts to the air box that flaps behind its mounting point. i put some insulator tape there as well so it doesnt slap the mounting surface. this is located behind the glovebox, attached to the airbox/filter door

 

I sure hope so. thanks again!

 

Ok, I need more info on this. Is there a thread on this?

 

http://www.tacomaworld.com/forum/2nd-gen-tacomas/209578-886-backup-light-mod.html

 

Finally got around to adding a first aid kit. Getting ready for summer trips.

 

Heres the website
http://www.paranoidfabrications.com/shop/category/toyota-tacoma/

 

Completed the diff breather mod. Moved it up to the drivers side cubby (the one with the door).

Wash and wax. It'll make it easier to keep the pollen off the truck

 

Installed my BAMF light bar and relocated the horns.

 

http://www.tacomaworld.com/forum/1s...5089-6-switch-plate-under-radio-location.html

 

For $65 I decided to give these a try.

 

URL=http://s817.photobucket.com/user/tim5161/media/20140410_154305_zpsupw6exvu.jpg.html][/URL]