What Have You Done To Your 2nd Gen Tacoma Today?

your front end makes that big FJ60 emblem look..............small.

 

I guess they assume everyone with bed mats would use the rail?

 

Mounted and wired in some fog lights that came off my sisters jeep a few years ago, found them in the shop and hooked em in to factory wires. Free=good

 

Is it considered mall-crawling if you crawl next to the mall rather than inside it?

 

Wash

Dry

Spray on clay lube(quick wax, clay lube spray or water with dish soap)

Clay with paint continuously wet, do not let dry.

When clay becomes dirty fold and flatten clay with clean part showing.

Wipe excess clay lube

Repeat until vehicle is completely clayed.

Wipe down vehicle with quick detailing spray or wash and dry vehicle again.

Apply wax, sealant, etc.

Finished.

 

Where you guys getting these??

 

Thanks brother ...

 

And don't drop the clay. And if you do, throw it away.

 

Very nice look!
is there a writeup on your interior l.e.d.'so PARBOY?

 

Washed, Vacuumed, Mcguires detailed interior, Mcguires quick waxed exterior paint.

 

Fixed my right retrofit HID projector so it shines level now. Huge pain. Tried to wire in the LED angel eyes to my DRL's. Now I don't have DRL's. Gonna see a guy about fixing that on monday.

 

Get the Dodge Sprinter D-rings instead: http://www.tacomaworld.com/forum/2nd-gen-tacomas/28533-installed-d-rings-bed-pics-18.html

 

You are welcome. Or, if you have a random orbital polisher you can try this:

https://www.detailersdomain.com/NanoSkin-Autoscrub-Fine-Foam-Pad-6-Inch_p_709.html

It works amazingly well, and is very quick. I have used it to take off small droplets of dried house paint before. Much, much quicker than clay.

 

Yeah but its too high to strap stuff down a lot of times. I'll get a lot more use out these then the ones up top.

Ebay. I think it was $23 for both shipped. I like these better then the Dodge rings because they aren't loose and wont rattle and they just seem to be a little more heavy duty compared to them. The other ones probably work fine though.

For you guys that are using the clay bar you might want to look into the speedy prep towel. Does the same job if not better, and in a fraction of the time.

 

I got a great price. Just traded straight across for my stock flares

 

Did the XM "stealth" antenna mod. I've never liked the magnetic antenna stuck on the roof, so my Old antenna was mounted on dash. Worked OK, but would lose signal frequently around trucks. New antenna is mounted under the bed rail near the tailgate. Vast improvement in signal strength.

 

Thank you! For the interior led stuff, I followed all the great advice and pics in this thread: http://www.tacomaworld.com/forum/li...ished-leds-cupholders-console-bed-lights.html

 

changed my oil, filter, front & rear differential and transfer fluids, greased my woody ......and the front shaft

 

Installed my Rigid Industries grille and 20" LED light bar!

 

I received my OEM roof rack - damaged, refused shipment from Fedex

I received my Extang Solid Fold Tonneau cover - punctured through the box and through the aluminum, refused shipment from Fedex

Nice work Fedex, continue to have sex with my shipments and pay the man for damage...The tonneau was actually "dropped off at my garage and the guy split"...guess what, signature required asshat..took back to the local Fedex store and said...here ya go, didn't sign for it.

Fedex sucks