2.8 pulley and afe

Ordered the 2.8 pulley and the afe intake. Should be here this week sometime. Just need to find a place to have an o2 bung welded in before I start changing things. Will post here on the results of the new parts as well as the plx gauges that I bought. Still undecided where I will have the bung welded in.

 

Got pulley and cai on. Sounds a lot better and went from 5.5 psi boost to 6.9. Afr went from below ten (10 is as low as my guage goes) to maybe 10.1 10.2. Sitting at 14.5 at idle. O2wideband after first cat.

 

from what i have read before, having the O2 sensor after the cat(s) alter the true a/f ratio. you might want to put it before to get a correct reading.

 

Not too worried about it. From what I have read its off by 0.4 +\- I can live with that. No more mods will be done to motor. Just wish I had not spent all he money on plx gauges. It was nice to see before and after but don't really want a permanent gauge now. Oh well. Live and learn I guess.

 

Its pretty damn close, ur fine............

I went from 6.5 to 8.5, def a nice bump in cold weather

 

That gauge will come in handy if things aren't running right.

 

I can't get it to read engine error codes. Cel codes is what I mean. Will have to make another call to plx and see what's up. Also can't figure for the life of me how to get it to read any obd data. Was told by another member that it would show trans temp but the gauge is definitely smarter than me. Will update here what I figure out.