Pelfreybilt ::: Front & Rear Bumper Options ::: 2nd Gen (05-15)

Whats the lead time on HC w/ tire gate?

 

Live in NTX too. Stunned I haven't been hit yet. Did you order one?

 

Gate versions are still a way out. Were around the 10-12 week mark on those

 

Love me some Pelfreybilt...can't wait until these (and some skids & sliders) are in my budget and on my Taco.

Later.

 

I don't own a 2016 or anything but just thought you guys might wanna fix this on your website, I'm assuming it must be an error lol just trying to help!

Look at the price for the sensor and light cut outs

 

Prob tomorrow or early next week

 

For those who have installed their bumper already, my passenger side is a bit lower than the driver side. I was told to use washers if you're unsatisfied and want to change the fitment a little bit, but if I want to raise it and I feel like putting washers on the passenger side would only push the bumper farther forward...

Here's a few pictures for reference, someone who has dealt with this I look forward to your reply!

Passenger top. Driver bottom.

 

Also what do you all do with your factory fog light wires that run from the old fogs to the switch to the left of the steering wheel??

 

I have my led fogs plugged in to the factory wiring allowing me to use the stock switch.

 

The stock wiring harness plug doesn't need alteration to use the Rigid Industries harness plug?

 

On my 2014 I had to cut off the factory plugs and wire in the Rigid ones.

 

So my new front bumper has a plate with two tabs on the ends that is a cover for the lightbar cutout. I don't want to install a lightbar, I want to install the supplied plate spacer to cover up the empty retangular hole in the center of the bumper.

My question is, how do I do this? The tabs on the plate seem to be offset. Is there a way I can install it into the bumper without having to use bolts on both sides to keep the plate from falling out?

 

Not sure what you're asking here... You need to use bolts to hold the filler plate in, or else it will just fall out.

 

Sorry, I shoulda told you. The plugs don't match, what I did was ordered the harness from Tap auto. I don't know if they still sell them, but it helps for when I remove the bumper, I don't have to do any cutting and splicing.

 

Not a problem! I'll just stick with the OTRATTW switches that are en route just waiting for their delivery

 

The regular rear plate bumper doesn't require any modification to fit, right? Just paint it and bolt it up?

 

Yep

 

Thanks. Yup, I called to confirm earlier today. Then ordered one.

 

I'm sure this has been asked, I didn't do a search.. so don't beat me up.. LOL..!!!

I have a buddy who wants to sell his 05-11 steel front bumper, I'm sure it works on the 12-14's but how bad of a gap is it near the lower light section.? @Pelfreybilt do the bumpers just have a set of welded triangles to accommodate for this..?

Thanks..!!!

 

Won't work. There's some steel that runs under your head lights that the 05-11 don't have (or ran differently?) that'll interfere with the bumper on your 14. You won't have any adjustment on the bumper and it'll sit forward a bit. Don't ask how I know...