MARYLAND TACOMAS

Need to put brakes back on and change diff fluid

 

I'm usually always driving one of my lifted yotas but today the wife and I had to run up to Harford co so I drove my old caddy. On the way up 7 I stopped to check out a spot where I use to ride my dirt bikes & quads years ago. And sure enough there was a bunch of guys on quads and SxS's riding there. Wish i wouldve been in one of my trucks. Those trails run up almost to the cecil co bridge. I plan to check it out next weekend with my LC.

 

Diff fluid doesn't look bad for the mileage must have been serviced before

 

Who did your press work?

 

Didn't do bearing it had very very little play compared to what I saw online so I took a chance at this point in time ..I just did the seal in the tube

 

Diff fluid drain and replace done, brakes tomorrow after work and hope it don't leak anymore.

 

The weather today was awesome, felt like April right? Wash and waxed the truck, put the Lumin-X on my fogs.

 

Shoes look ruined. WOULD REPLACE

 

Lamin X

I only know because i bought some on sale and never installed it

Looks good. What are your initial impressions about going yellow?

 

What are you talking about there fine lol,I don't use the brakes anyway at least that's what my wife says..Actually cleaned them off to reuse for a week until I'm sure it's not gonna leak anymore then will replace it's a shame there's a ton of pad still on them.YEAH I'm a ghetto redneck.

 

I like the look on my truck and when I tried them last night they were still pretty bright. They are a pain to apply though.

 

Did you remove the housings or do it with them installed?

 

I did them installed...probably would have been easier with them off of the truck. The wrinkles are at the bottom of the lens, unless you get close you wouldn't even see em. But I know that it's there

 

Well, that explains it. A couple screws to loosen the fender liner, then unclip the fog light harness and the fog light is clipped in at the adjuster, unclip that and wiggle one side out before the other. It sucks, but it does make it easier. Plus the lights won't come out of adjustment.

 

These Rokblokz are great. Thanks for the recommendation fellas!

 

Runner is still down I cracked a bleeder screw I think cause I can't get any pedal continually goes to the floor

 

Took my base model v2.0 down on to the damn my buddy and I have been clearing. Took a potato pic. I need some meats.

Also towed a boat for the first time with it. V6 tows so much better than the I4.

 

Thanks AR...next time, assuming I don't just replace the whole light with yellow, I'm gonna pull them out of the truck. Checked them today and some of the wrinkles look like they smoothed out abit.

 

I have two sets of oem fogs so i plan on just swapping them back and forth to see how they are